2008, Disco 3, HSE, TDV6, Auto with Air Suspension
Does anyone have the LR spec's for the Wheel alignment (Front & Rear) ?
Had the wheel alignment done on a 4 Wheel, Hunter setup last week and the following figures were given after adjustments, which were done in Tight Tolerance Mode.
The car is drifting slightly to the left and the steering wheel position is very slightly biased to the right when driving on a straight road. Tyre pressures are set for normal use and there is a full tank of fuel.
The rear suspension has been completely renewed including, bushes,ball joints, toe rods and wheel bearings. The front suspension has had the wheel bearings and track rod ends replaced- the upper and lower ball joints are good.
Front Toe 0 deg 22' (Total) Rear Toe -0 deg 09' (Total)
The car is going back there tomorrow for another check.
Before the car was taken in, the steering followed a straight line and the steering wheel was in the straight ahead position.Relocated to Mid France from N. Wales March 2021
Rovacomlite and IDD/ SSD diagnostics user
Previous Landies
3.9 SE Classic
3.5 V8 Disco
4.6 P38 HSE
L322 Vogue HSE
TD4 ES Freelander 1
30th Apr 2019 7:31 pm
Sea Raider
Member Since: 01 Nov 2016
Location: None
Posts: 4450
Relocated to Mid France from N. Wales March 2021
Rovacomlite and IDD/ SSD diagnostics user
Previous Landies
3.9 SE Classic
3.5 V8 Disco
4.6 P38 HSE
L322 Vogue HSE
TD4 ES Freelander 1
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
