Member Since: 29 Apr 2018
Location: Nova Scotia
Posts: 46
Rear Wiper Relay coil fault
Good day,
Looking for some direction with the following fault code.
B1C77-14 (2F) Rear wiper relay coil circuit - General electrical failure - circuit short to ground or open
I did a little work on the vehicle today. First was installing the wiring harness for towing followed by the replacement of the front sunroof drain lines and elbows.
I cannot recall if the rear wiper fault was present when I did a scan prior to commencing work on the harness or if it appeared after the harness or after the CJB was removed for the drain lines. Either way it is present now and returns after I clear them. Rear wiper is not working. Haven't used the rear wiper in sometime.
I checked all the connections in the access panel in the rear incase I bumped something and they all appear solid.
30th Aug 2018 7:54 pm
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10499
Relay is near the towbar connector. So you probably disturbed it
30th Aug 2018 8:16 pm
RyanR
Member Since: 29 Apr 2018
Location: Nova Scotia
Posts: 46
Took a poke around the rear wiring. Found the relays and the problem. The wires connected to the body side of the harness that the relays plug into are very corroded and one has broken off (Grey with purple stripe)
As I do not have much experience on the electrical side of things, how should this be addressed? I suspect the relays may be fine and it is the wiring on the connector side that is the issue. How does one go about cleaning up the connector/wires and re-pin the broken one?
Click image to enlarge
[/URL]
Click image to enlarge
[/URL][/img][/img]
30th Aug 2018 8:30 pm
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10499
Blimy.
Know an auto electrican?
I'll post an ebay link tomorrow
30th Aug 2018 9:21 pm
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10499
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum