I've replaced O/S/R height sensor and replaced the harness plug, I now have no suspension faults so far so good, but on trying to do the guided calibration in the iid tool everything goes ok until I try to apply the new values, then I get "Operation failed E89" tried a couple of times and get the same message,
Checked and double checked I had the right sensor for that corner and the wiring was done a wire at a time so I'm positive there are no issues there.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
