Member Since: 10 Jun 2014
Location: County Durham
Posts: 82
i need some advice
hi
i have purchased a lead and downloaded the software to find faults and reset the fbh but this is as far as i get. it wont go any further.
could someone offer me some advice to get it going. thanks
25th Mar 2018 4:56 pm
Russell
Member Since: 23 Aug 2007
Location: Kent
Posts: 10564
What are you using, this may tell people a little more and then they may be able to help youMY17 D5 1st Edition Namib Orange
MY15 D4 HSE Kaikoura Stone
MY12 D4 HSE Nara Bronze Sold and gone
MY11 D4 HSE Stornaway Grey Sold and gone
D3 S spec Silver Sold and gone
Tow bar, full length roof bars, side steps, tow bar storage unit, surround camers.
D4 camera club
25th Mar 2018 5:05 pm
The gamekeeper
Member Since: 10 Jun 2014
Location: County Durham
Posts: 82
ah sorry. its the blue lead which you plug into your laptop then put the wire into the number 2 pin on the fbh. ive been told to clear the faults then prime it. i know that sounds a bit vague but i dont know what its called
25th Mar 2018 6:09 pm
zinke
Member Since: 22 Feb 2014
Location: Scunthorpe
Posts: 584
Remover the fuse for the fbh in the box next to the battery, count to 10 and then put it back in. Then try to connect again, this normally works for me.
Pete.IID, webasto software and workshop facility's available.
25th Mar 2018 9:10 pm
Rob9990
Member Since: 06 May 2017
Location: Southeast
Posts: 72
When I did mine. I purchased the fbh diagnostic lead from the sites shop and plugged that into the vag lead. Had to fiddle around with the software but works fine now.
25th Mar 2018 9:18 pm
conman69
Member Since: 11 Aug 2012
Location: Norfolk
Posts: 431
^+1 diagnostic lead from club shop Discovery3 TDV6 GS
Disco3.co.uk front orange +white tailgate stickers
Belts, pulleys, oil pump replaced, double tow-bar electrics
Land Rover rubber mats throughout, tinted windows, wind deflectors, smoked side repeaters, retro fitted Garmin, smooth leather steering wheel, cruise control + radio switches, 19" HSE wheels, Bearmech side-tubes, BAS IFBH module, roofbars.
LML Star Deluxe
26th Mar 2018 4:02 am
Narpy
Member Since: 18 Jul 2011
Location: Stockport
Posts: 7830
Your lead must be recognised by your computer to proceed. There is an issue with designating a COM port that confuses some users but firstly you must have the correct drivers installed on your PC so the lead will actually work. After you've done that it is pretty straight forward.
Have you installed the drivers or have you just gone for plug + play? ( If you've gone for the latter, it probably wont work )Mods:
Front Fogs + Halos
FBH Remote Control
The 1st Ever RRS Modded Grill
Garmin Nuvi + D4 Surround + Reversing Camera.
D4 Steering Wheel.
Rear Boot Spoiler.
Twin Brake Lights.
Wing Mirror Indicator Repeaters.
Long Roof Rails
Make your own Narpy grill thread
I'm not scared, I'm outta here.
26th Mar 2018 5:46 am
The gamekeeper
Member Since: 10 Jun 2014
Location: County Durham
Posts: 82
its one of those leads the sites sell. the lad i bought it off is the lad who got my burner goin the first time it stopped so i know the lead is ok. ile try pulling the fuse first
26th Mar 2018 9:34 am
Coo
Member Since: 01 Jun 2015
Location: Fife, Scotland
Posts: 284
It's maybe using the wrong COM port...
26th Mar 2018 10:05 am
The gamekeeper
Member Since: 10 Jun 2014
Location: County Durham
Posts: 82
the youtube video that the lead goes with says use a com below 20. when the com is picked it finds it but wont go past the picture i posted
26th Mar 2018 10:13 am
conman69
Member Since: 11 Aug 2012
Location: Norfolk
Posts: 431
Have you tried running diagnostics by clicking the tab at the topDiscovery3 TDV6 GS
Disco3.co.uk front orange +white tailgate stickers
Belts, pulleys, oil pump replaced, double tow-bar electrics
Land Rover rubber mats throughout, tinted windows, wind deflectors, smoked side repeaters, retro fitted Garmin, smooth leather steering wheel, cruise control + radio switches, 19" HSE wheels, Bearmech side-tubes, BAS IFBH module, roofbars.
LML Star Deluxe
26th Mar 2018 11:26 am
The gamekeeper
Member Since: 10 Jun 2014
Location: County Durham
Posts: 82
yes mate it opens that screen then stops. the green bar doesn’t work go along
26th Mar 2018 12:05 pm
conman69
Member Since: 11 Aug 2012
Location: Norfolk
Posts: 431
So you have selected drive W-BUS and when you click Start diagnostics the WTT initialisation box comes up,,,
Which COM port are you using, mine was set on 4 but changed to 6
Sorry I know I'm not much help, if I was anywhere near my vehicle I'd set up the WTT and check it out but unfortunately Ii'm away on businessDiscovery3 TDV6 GS
Disco3.co.uk front orange +white tailgate stickers
Belts, pulleys, oil pump replaced, double tow-bar electrics
Land Rover rubber mats throughout, tinted windows, wind deflectors, smoked side repeaters, retro fitted Garmin, smooth leather steering wheel, cruise control + radio switches, 19" HSE wheels, Bearmech side-tubes, BAS IFBH module, roofbars.
LML Star Deluxe
26th Mar 2018 2:14 pm
The gamekeeper
Member Since: 10 Jun 2014
Location: County Durham
Posts: 82
it does it on all the free coms below 20
26th Mar 2018 2:33 pm
Narpy
Member Since: 18 Jul 2011
Location: Stockport
Posts: 7830
For fear of repeating myself could I suggest you re-read my post and answer the question regarding the drivers?
If you haven't installed the drivers, you'll never get it working. Mods:
Front Fogs + Halos
FBH Remote Control
The 1st Ever RRS Modded Grill
Garmin Nuvi + D4 Surround + Reversing Camera.
D4 Steering Wheel.
Rear Boot Spoiler.
Twin Brake Lights.
Wing Mirror Indicator Repeaters.
Long Roof Rails
Make your own Narpy grill thread
I'm not scared, I'm outta here.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
)
