KS2017
Member Since: 01 Jul 2017
Location: Essex
Posts: 7
|
Nanocom Evolution EAS Ride Height |
|
Hi I'm brand new here after just buying a nanocom evolution recently.
I had a problem with one corner sensor so replaced it. Run a calibration using another diagnostics tool. Long story short, it failed and has wiped all the calibration settings for all three ride heights.
I have looked through the Nanocom website and searched through google i can find heights in the IID Tool but not Nanocom.
Please any one help give me a starting point of what values I should be looking to start with......
Please see the current setting in the photos
Thank you in advance
Karen
|
3rd Jul 2017 7:41 pm |
|
|
KS2017
Member Since: 01 Jul 2017
Location: Essex
Posts: 7
|
All now reset to factory settings thanks to a friend who is a master technician.
While he was looking in at it, he asked if we were having issues with the parking brake and a few other items which we confirmed we did have issues with. He confirmed that all the issues we were having were most likely be because of a known fault with the original loom. The loom is so encase, it holds water and corrodes the wiring!
Just waiting to replace the loom the upgraded version and reset the ride heights yet as they have thrown out the factory settings yet again.
He is going to get us a new improved loom and help us fit it at in a week or two.
|
17th Jul 2017 1:25 pm |
|
|