sean 471
Member Since: 26 Apr 2011
Location: Sheffield
Posts: 2990
  
|
| Fuel rail pressure sensor can it be changed on its own |
|
Getting this fault code come up. It only happens intermittently and only when I switch the ignition on. I looked at the Haynes manual anf it says it can't be repaired in its own. Any ideas?
P0191-24 (2C) Fuel rail pressure sensor range/performance - General signal failure - signal stays high
So can I change it on its own?
Last edited by sean 471 on 2nd May 2017 4:30 pm. Edited 1 time in total
|
 1st May 2017 1:21 pm |
|
|
sean 471
Member Since: 26 Apr 2011
Location: Sheffield
Posts: 2990
|
Managed to clear the fuel sensor fault but every time I clear the code below it just comes back on when I pull out the iid. Car now in limp mode and I need it for tomorrow. 
Vehicle Dynamic
U0401-68 (2B) Invalid data received from engine control module/powertrain control module - Algorithm based failure - event information
( on 01-05-2017 13:41:44 at 266288 km )
|
| 1st May 2017 1:50 pm |
|
|
sean 471
Member Since: 26 Apr 2011
Location: Sheffield
Posts: 2990
|
Managed to now clear this fault but still suspect the fuel rail sensor is playing up. Has anybody managed to change one of these? I have seen them for sale so hoping it's possible.
|
| 1st May 2017 2:55 pm |
|
|
