Advertise on DISCO3.CO.UK
Forum · Gallery · Wiki · Shop · Sponsors
DISCO3.CO.UK > Technical (D3)

Injector values after replacement
Post Reply  Down to end
Page 1 of 1
gilesharrison
 


Member Since: 23 Oct 2016
Location: Penrith
Posts: 143

United Kingdom 2005 Discovery 3 TDV6 HSE Auto Buckingham BlueDiscovery 3
Injector values after replacement

Following the advice of a respected LR independent, I decided to replace my injectors on my MY06 TDV6.

Due to time constraints, I replace the right-bank first, and then the left back about a week later. All 6 are now new, VDO/ Siemens injectors. My glow plugs have all been replaced and the garage tested these and informed me they are working fine.

The car is running well - starts and runs smoothly, good improvement in power and mpg. I still get a slight puff of white smoke for the first 20 sec on the first start up of the day but it clears quickly. Any reason for this?

My main question, when I check the injector values on my IID BT, there is a bit difference between the two banks. The right-bank (injectors 1-3-5) are all running around 800, whereas the left-bank (2-4-6) are all around 1200.

Any ideas why this would be? I've drive the car for around 100 miles so I would have thought it should have settled down by now. Would a hard reset do anything?
  
Post #178154921st Feb 2017 10:25 am
View user's profile Send private message View poster's gallery Post Reply
Display posts from the last:  
Post Reply Back to top
Page 1 of 1
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO3.CO.UK Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO3.CO.UK is independent and not affiliated to Land Rover.
Switch to Mobile Site