Advertise on DISCO3.CO.UK
Forum · Gallery · Wiki · Shop · Sponsors
DISCO3.CO.UK > Technical (D3)

IID tool key programming
Post Reply  Down to end
Page 1 of 3 123>
disco4ever
 


Member Since: 23 Dec 2013
Location: under the car
Posts: 208

Germany 2006 Discovery 3 TDV6 HSE Lux Auto Alaska WhiteDiscovery 3
IID tool key programming

my every day key got bang. It was the micro switch in the middle of the pcb which got loose. A pro tried to solder it on without success.

Took the 2nd key out and all was good until I figured to be needing a spare.

Bought a key incl. pcb and Panasonic battery but could not programm it. Bought another key from another vendor but could not programm it either.

Following the instructions all goes well until the "routine starts" message for the 2nd key prgramming. It stops after 3 seconds.

Taking a look at the fault messages it throws up
''
Body Control

B1B01-87 (2E) Key transponder - Bus signal/message failure - missing a message
( on 19-07-2014 19:55:38 at 203700 km )

''

Is my spare key knackered as well?

I
 Achim

own garage certified LR tech

Disco 2 TD5 MY 2001 - gone but still driven by another owner
Disco 3 TDV6 HSE MY 2005 fully loaded and kept alive by IID BT
+ EGRs blanked
+ Timing belt done
+ front upper / lower wishbones done
+ front wheel bearings done 
 
Post #176181211th Jan 2017 7:23 pm
View user's profile Send private message View poster's gallery Reply with quote
Pete K
 


Member Since: 15 Jan 2016
Location: GL
Posts: 876

England 2005 Discovery 3 TDV6 HSE Auto Rimini RedDiscovery 3

try clearing all the fault codes and then repeat Confused
  
Post #176182211th Jan 2017 7:46 pm
View user's profile Send private message View poster's gallery Reply with quote
disco4ever
 


Member Since: 23 Dec 2013
Location: under the car
Posts: 208

Germany 2006 Discovery 3 TDV6 HSE Lux Auto Alaska WhiteDiscovery 3

I cleared all the faults but the key still resists being programmed.

Can it be that the pcb of the new keys are knackered? Or is above fault message a sign that my remaining original key is knackered?
 Achim

own garage certified LR tech

Disco 2 TD5 MY 2001 - gone but still driven by another owner
Disco 3 TDV6 HSE MY 2005 fully loaded and kept alive by IID BT
+ EGRs blanked
+ Timing belt done
+ front upper / lower wishbones done
+ front wheel bearings done 
 
Post #176182811th Jan 2017 7:54 pm
View user's profile Send private message View poster's gallery Reply with quote
Pete K
 


Member Since: 15 Jan 2016
Location: GL
Posts: 876

England 2005 Discovery 3 TDV6 HSE Auto Rimini RedDiscovery 3

sorry, don't know. Neutral

Sounds more like the key or IID

Where did you get the keys from ?
  
Post #176183111th Jan 2017 7:58 pm
View user's profile Send private message View poster's gallery Reply with quote
gstuart
 


Member Since: 21 Oct 2016
Location: kent
Posts: 960

United Kingdom 2005 Discovery 3 TDV6 Base 7 Seat Auto Java BlackDiscovery 3

does the mhz match ur landy

uk is 433 hz , europe i believe is 315 mhz

just wondering on the off chance if it's the same mhz as ur transponder unit

hope that's not a daft answer
 

Last edited by gstuart on 12th Jan 2017 12:20 am. Edited 2 times in total 
Post #176183311th Jan 2017 7:59 pm
View user's profile Send private message View poster's gallery Send e-mail Reply with quote
beanie
Site Sponsor 


Member Since: 12 Mar 2011
Location: In the garage messing with something
Posts: 12731

England 2013 Discovery 4 3.0 SDV6 GS Auto Fuji WhiteDiscovery 4

I've done keys with IID no problem , are they new or "refurbished" keys?
 Altox GSM FBH controller thread


IID Pro MV License - D3, D4 & RRS - Enabling, Updates, D4 & RRS Timed / Remote Climate, D4 Bluetooth fitting
PM me for details




Owner of the original "Beanie" grille
D4 & RRS style D3 grilles made to order
  
Post #176183611th Jan 2017 8:04 pm
View user's profile Send private message View poster's gallery Send e-mail Reply with quote
disco4ever
 


Member Since: 23 Dec 2013
Location: under the car
Posts: 208

Germany 2006 Discovery 3 TDV6 HSE Lux Auto Alaska WhiteDiscovery 3

keys were 433 mhz spec.

1st key I bought was one from Far East, 2nd key was from a German reseller

http://www.ebay.de/itm/201604436995?_trksi...EBIDX%3AIT

weired, both keys are not programmable?
 Achim

own garage certified LR tech

Disco 2 TD5 MY 2001 - gone but still driven by another owner
Disco 3 TDV6 HSE MY 2005 fully loaded and kept alive by IID BT
+ EGRs blanked
+ Timing belt done
+ front upper / lower wishbones done
+ front wheel bearings done 
 
Post #176188411th Jan 2017 9:10 pm
View user's profile Send private message View poster's gallery Reply with quote
gstuart
 


Member Since: 21 Oct 2016
Location: kent
Posts: 960

United Kingdom 2005 Discovery 3 TDV6 Base 7 Seat Auto Java BlackDiscovery 3

does seem strange

there's a u tube video that shows u how to do the sequence

think u have to start with the original

i did buy one first from the far east , but when it arrived i looked on the side it said 315 mhz



sounds daft but have u looked on the side of the fob to see if it says 433mhz

pic of the key that turned up from china , ordered a 433 but a 315mhz turned up

Thumbs Up

ps sorry it was 315 mhz not 333 mhz, apologise
  
Post #176196012th Jan 2017 12:15 am
View user's profile Send private message View poster's gallery Send e-mail Reply with quote
gstuart
 


Member Since: 21 Oct 2016
Location: kent
Posts: 960

United Kingdom 2005 Discovery 3 TDV6 Base 7 Seat Auto Java BlackDiscovery 3

disco4ever wrote:
keys were 433 mhz spec.

1st key I bought was one from Far East, 2nd key was from a German reseller

http://www.ebay.de/itm/201604436995?_trksi...EBIDX%3AIT

weired, both keys are not programmable?


found the utube video for u

see if it's helps at all

  
Post #176196312th Jan 2017 12:26 am
View user's profile Send private message View poster's gallery Send e-mail Reply with quote
disco4ever
 


Member Since: 23 Dec 2013
Location: under the car
Posts: 208

Germany 2006 Discovery 3 TDV6 HSE Lux Auto Alaska WhiteDiscovery 3

this is the pcb I have but I cannot tell it is 433 mhz or the other one.

 Achim

own garage certified LR tech

Disco 2 TD5 MY 2001 - gone but still driven by another owner
Disco 3 TDV6 HSE MY 2005 fully loaded and kept alive by IID BT
+ EGRs blanked
+ Timing belt done
+ front upper / lower wishbones done
+ front wheel bearings done 
 
Post #176231312th Jan 2017 6:32 pm
View user's profile Send private message View poster's gallery Reply with quote
pjm-84
 


Member Since: 04 Oct 2016
Location: Southampton
Posts: 150

United Kingdom 2005 Discovery 3 4.4 V8 HSE Auto Zambezi SilverDiscovery 3

Recently had this problem. Would not program. I agreed a 75% refund with the reseller and kept the key as I bought it on a punt.

I bought a "cleaned" LR key. Was expecting the same hassle. Worked first time.
  
Post #176234912th Jan 2017 7:12 pm
View user's profile Send private message View poster's gallery Reply with quote
disco4ever
 


Member Since: 23 Dec 2013
Location: under the car
Posts: 208

Germany 2006 Discovery 3 TDV6 HSE Lux Auto Alaska WhiteDiscovery 3

how much is a new LR key? Have not tried this route yet.
 Achim

own garage certified LR tech

Disco 2 TD5 MY 2001 - gone but still driven by another owner
Disco 3 TDV6 HSE MY 2005 fully loaded and kept alive by IID BT
+ EGRs blanked
+ Timing belt done
+ front upper / lower wishbones done
+ front wheel bearings done 
 
Post #176240912th Jan 2017 8:18 pm
View user's profile Send private message View poster's gallery Reply with quote
beanie
Site Sponsor 


Member Since: 12 Mar 2011
Location: In the garage messing with something
Posts: 12731

England 2013 Discovery 4 3.0 SDV6 GS Auto Fuji WhiteDiscovery 4

I've programmed these keys without issue Thumbs Up

434 MHz

eBay Item No. 331647411980
 Altox GSM FBH controller thread


IID Pro MV License - D3, D4 & RRS - Enabling, Updates, D4 & RRS Timed / Remote Climate, D4 Bluetooth fitting
PM me for details




Owner of the original "Beanie" grille
D4 & RRS style D3 grilles made to order
  
Post #176241912th Jan 2017 8:30 pm
View user's profile Send private message View poster's gallery Send e-mail Reply with quote
gstuart
 


Member Since: 21 Oct 2016
Location: kent
Posts: 960

United Kingdom 2005 Discovery 3 TDV6 Base 7 Seat Auto Java BlackDiscovery 3

disco4ever wrote:
this is the pcb I have but I cannot tell it is 433 mhz or the other one.



when u flick the key out, if u look on the side u can see what mhz it is
  
Post #176242512th Jan 2017 8:36 pm
View user's profile Send private message View poster's gallery Send e-mail Reply with quote
pjm-84
 


Member Since: 04 Oct 2016
Location: Southampton
Posts: 150

United Kingdom 2005 Discovery 3 4.4 V8 HSE Auto Zambezi SilverDiscovery 3

£40

From this chap.

http://www.ebay.co.uk/itm/112245073539?_tr...EBIDX%3AIT

I contacted the guy before buying and he was very helpful

This one didn't work

http://www.ebay.co.uk/itm/291654792448?_tr...EBIDX%3AIT
  
Post #176247512th Jan 2017 9:36 pm
View user's profile Send private message View poster's gallery Reply with quote
Display posts from the last:  
Post Reply Back to top
Page 1 of 3 123>
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO3.CO.UK Copyright © 2004-2017 Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums Follow DISCO3.CO.UK on twitter

DISCO3.CO.UK is independent and not affiliated to Land Rover.
Switch to Mobile Site