Member Since: 04 Nov 2016
Location: hampshire
Posts: 62
IID Fault codes
hi all,
apart from the transfer case one see this thread http://www.disco3.co.uk/forum/topic153109.html
are there any i should worry about?
Parking sensors is another story.
flashing dash light and no sounds at all for anything.
VIN SALLAAA135A313952
Model L319 - Discovery 3 2005
Vehicle scanned on 24 Nov 2016 16:18:11
IIDControl 2.9.4.3 Android - IIDTool BT V3.0 B2444
Body Control
• B1C09-73 (2F) Driver's left/right mirror motor circuit - Mechanical failure - actuator is stuck closed
( on 24-12-2014 13:57:48 at 175643 mi )
• B1C26-3A (2F) Pedal motor feedback circuit - Frequency modulation/pulse width modulation failure - incorrect, has too many pulses
( on 24-12-2014 13:57:48 at 175643 mi )
• B1C32-13 (2F) Steering column tilt solenoid - General electrical failure - circuit open
( on 24-12-2014 13:57:48 at 175643 mi )
• B1C34-13 (2F) Steering column telescope solenoid - General electrical failure - circuit open
( on 24-12-2014 13:57:48 at 175643 mi )
• B1C57-14 (2F) Passive start ignition relay coil circuit - General electrical failure - circuit short to ground or open
( on 24-12-2014 13:57:48 at 175643 mi )
Parking Aid
• B1B57-11 (2F) Front sensors power circuit - General electrical failure - circuit short to ground
• B1B58-11 (2F) Rear sensors power circuit - General electrical failure - circuit short to ground
Traffic Message
• B1A56-18 (2F) Antenna circuit - General electrical failure - circuit current below threshold
Transfer Case
• P1807-00 (2F) Four-wheel drive high ratio - short circuit to ground
( on 24-12-2014 13:57:53 at 175646 mi )
Ventilation
• B1B78-84 (2F) System pressure - Bus signal/message failure - signal is below allowable range
( on 24-12-2014 13:57:51 at 175646 mi )
24th Nov 2016 4:55 pm
Robbie
Member Since: 05 Feb 2006
Location: ¯\_(ツ)_/¯
Posts: 17932
No, just clear them and see what, if anything, comes back. From the recorded milage you can see that a number of codes came from one event.
Land Rover - Turning Drivers into Mechanics Since 1948
Member Since: 04 Nov 2016
Location: hampshire
Posts: 62
HI Robbie,
Cleared them quite a few times.
They still reappear.
24th Nov 2016 5:26 pm
jtimkey
Member Since: 04 Nov 2016
Location: hampshire
Posts: 62
hard reset?
24th Nov 2016 5:41 pm
PatGAPInnov Site Sponsor
Member Since: 02 Dec 2011
Location: Montreal
Posts: 745
I would look at the ones in the transfer case, ventilation and parking aid. The Body Control and Traffic messages ones are almost always present on these vehicles for no apparent reason.http://www.gap-diagnostic.com/
24th Nov 2016 6:13 pm
jtimkey
Member Since: 04 Nov 2016
Location: hampshire
Posts: 62
thanks Pat,
i have done all the splices in each loom channel,
i have checked all the fuses.
Do i need to check in the NSF wheel arch at the connectors maybe for the transfer case one?
Also he HVAC one means i have no gas?
tbh i havent tried the sir con yet.
Parking senors just flash no noises front or rear.
going to check the looms next i think
24th Nov 2016 6:18 pm
JAMOIS
Member Since: 11 Sep 2012
Location: Bretagne
Posts: 1
Trouble code
I've the same issue on my D3-2005. I've made a software reset through the IIDtools but DTC are still there. Did you figure out the problems and is anynone noticed a issue with low power voltage on the battery as it seems that those DTC raise up when starting the engine ?
4th Jan 2017 4:02 pm
jtimkey
Member Since: 04 Nov 2016
Location: hampshire
Posts: 62
so the low and high range switch was my transfer case fault, air con needed re gasing and every parking sensor was shot! now the air reservoir is leaking. one day i will get to no fault codes !!
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum