Member Since: 28 Feb 2012
Location: Kent
Posts: 301
[For Sale] Clearout of parts - seats, mats, commercial conversion, prices reduced
Car has been written off, and I will be replacing it with something else, so no longer need all the bits that I added over the years. I will add to this as I find more parts in the garage. All prices are collected.
Load Cover with handle mod (although I couldn't get a black handle at the time): £60
RLD Wheel Protector for 20" wheels: £40 SOLD
Rosen Rear Screen Entertainment. Two screens, with DVD player in each headrest (although headrest one no longer plays it's own DVDs, I was going to return it for repair, but kids just both watch the same film). Complete with loom, remote control, main control unit and a pair of wireless headphones. Loom also includes connector at rear to allow it to be wired in to the AUX circuit to play through the car's speakers and with an HDMI input to allow playing media from other sources. Headrest in ebony with lunar stitching to match rest of seats. £250
Genuine Land Rover rubber floor mats for rows one and two: £60 SOLD
Detachable tow bar with two keys, cover and foam insert for storage in the boot alcove (forgot to remove the bracket that holds the foam part). Not used by me.: £100 SOLD
RLD Sump Guard (this was to fit a MY2011 D4, I'm not sure which other years it might fit. Black powder coated, generally good condition, but a fairly new ding at the edge of the hole for the recovery point: £60 SOLD
Seat Memory Module: £20
Rear Power Panel, Driver's Side, bought from a member here: £40
Pair of rear window motors (commercial has these disabled by filling connectors with sealant - I had to replace with new to get them to work). £80 SOLD
Rear Load Area Mat (commercial): £40 SOLD
Rear Load Area Extension. When I added seats to my commerical, there was a 6" gap between the end of the flat load area and the back of the seats. I fabricated this little frame to support the trimmed down piece of floor to fill the gap perfectly. The above load area mat is now supported for its full length and no more stuff dropped into that gap. £40
D4 Ipod curly lead adapter, plugs into the special ipod socket in the cubby box: £10 SOLD
Dog Guard. Complete with all brackets and knobs. Foam part where it presses against the interior trim on one side of the brackets has become detached, otherwise in good condition: £80 SOLD
Fuel Burning Heater - remote, antenna and receiver, needs to be enabled after fitting: £120 SOLD
Traxide D3-DU system with split charge, cabling to run to rear of car, Anderson connector, low voltage battery cutout to allow rear power connectors to be used for eg a fridge. £150
Optima Yellow Top Battery and clamp to hold it in the second battery box of a D4 (I had to move some stuff out of the way - following instructions in this thread: https://www.disco3.co.uk/forum/fitting-yel...t=traxide. £80
Ashtray assembly (removed so I could fit my CB): £10
Removable Towbar Locking Plate, unused, as supplied without bolts: £15 SOLD
Jack Adapter (unused - didn't fit my jack): £15 SOLD
Front Electric Heated Seats from an HSE, Ebony leather with lunar stitching. Some storage marks. I've cleaned and fed the leather, but some marks remain. Headrests are as new, but one of the plastic surrounds for one of the holes for the headrest in the top of the seat is missing. Not great photos, I'll try and get some more later. £400 SOLD
Rear seats, 60/40 split, heated, ebony leather with lunar stitching: £450 SOLD
Plug for removable towbar: £5 SOLD
Genuine Land Rover Roof Bars with bag and keys: £60 SOLD
RLD CB Aerial Mount £20 SOLD
Rear Seat Seat Belts (outer pair only, not the one integral with the seats) £100 SOLD
Rear heated seats loom, switches and modules. I had to make up some adapters to get this loom to fit the existing loom in my car, these are included, you may not need them. £150 SOLD
Handle for front seat lumbar adjustment £5
Trim piece for under rear seats (40% seat) from RRS to stop stuff hiding under seats £10
Trim piece for under rear seats (60% seat) from RRS as above £10
Front Seat Trim (goes under front of seat and hides wiring, etc - not standard on my commerical): £10 SOLD
Rear View Camera (ebay special) £10 SOLD
Switch Pack for Front Seat Driver's Side LR015375 :£100
Puddle lights for front doors: £10 SOLD
Last edited by Inigo on 7th Oct 2018 9:17 pm. Edited 19 times in total
2nd Jun 2018 10:53 am
DSL Keeper of the wheelie bin
Member Since: 11 May 2006
Location: Off again! :-)
Posts: 73134
What does the electrical panel have in it?
And where about in Kent?
2nd Jun 2018 11:00 am
Inigo
Member Since: 28 Feb 2012
Location: Kent
Posts: 301
Fuses, switch (for whole panel), voltmeter, 2 x 12v cigar lighter style sockets and 1 double USB (2.1A and 1A).
Herne Bay.
2nd Jun 2018 11:15 am
DSL Keeper of the wheelie bin
Member Since: 11 May 2006
Location: Off again! :-)
Posts: 73134
2nd Jun 2018 11:32 am
ibruceuk
Member Since: 20 Mar 2018
Location: Lancashire
Posts: 105
Hi
Would you consider posting the mats?
Cheers
Ian
2nd Jun 2018 12:14 pm
Inigo
Member Since: 28 Feb 2012
Location: Kent
Posts: 301
Yes, happy to post, but likely to be quite expensive (they are heavy). If interested, I could price up postage.
2nd Jun 2018 12:19 pm
Gazzdid
Member Since: 13 Nov 2017
Location: Cannock
Posts: 158
I noticed you have stated (commercial) on the rear load arra mat. Do you know what’s different to the standard type? Will it fit and cover everything?
2nd Jun 2018 12:48 pm
Inigo
Member Since: 28 Feb 2012
Location: Kent
Posts: 301
I'm not actually sure, I just mentioned it in case it was different. In the commercial there was a frame that held a board to make the area behind the two rows of seats completely flat and this mat covered that area completely.
Last edited by Inigo on 2nd Jun 2018 1:28 pm. Edited 1 time in total
2nd Jun 2018 1:02 pm
DSL Keeper of the wheelie bin
Member Since: 11 May 2006
Location: Off again! :-)
Posts: 73134
It looks identical to the standard boot mat.
2nd Jun 2018 1:10 pm
Inigo
Member Since: 28 Feb 2012
Location: Kent
Posts: 301
Thank you!
2nd Jun 2018 1:28 pm
dorianwoolger
Member Since: 11 May 2018
Location: Tangmere
Posts: 223
Gazzdid wrote:
I noticed you have stated (commercial) on the rear load arra mat. Do you know what’s different to the standard type? Will it fit and cover everything?
Looks the same as my standard one.Dorian Woolger
Amateur Call: 2E0FSI
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
