Advertise on DISCO3.CO.UK
Forum · Gallery · Wiki · Shop · Sponsors
DISCO3.CO.UK > Technical (D3)

suspension normal height is to low
Post Reply  Down to end
Page 1 of 2 12>
Saulius Ruzgys
 


Member Since: 02 May 2016
Location: Wisbech
Posts: 15

United Kingdom 2007 Discovery 3 TDV6 SE Auto Unknown ColourDiscovery 3
suspension normal height is to low

Hi

suspension normal height is to low, no warning lights all functions working

when going over speed bump car is jumping

any comments

thanks [/code]
  
Post #166924218th Jun 2016 7:56 am
View user's profile Send private message View poster's gallery Reply with quote
tayaste
 


Member Since: 15 May 2013
Location: Chester
Posts: 7633

United Kingdom 2008 Discovery 3 TDV6 HSE Auto Stornoway GreyDiscovery 3

Sounds like it's on its bump stops.
What's the actual height at?
   
Post #166924818th Jun 2016 8:33 am
View user's profile Send private message View poster's gallery Reply with quote
Saulius Ruzgys
 


Member Since: 02 May 2016
Location: Wisbech
Posts: 15

United Kingdom 2007 Discovery 3 TDV6 SE Auto Unknown ColourDiscovery 3

Hello it's not completely down but definitely not in the normal height
  
Post #166925318th Jun 2016 8:43 am
View user's profile Send private message View poster's gallery Reply with quote
tayaste
 


Member Since: 15 May 2013
Location: Chester
Posts: 7633

United Kingdom 2008 Discovery 3 TDV6 HSE Auto Stornoway GreyDiscovery 3

If it's defiantly not all the way down, it might just need a height calibration. What does the display say, which height mode is it in.?

What car is it?
   
Post #166925518th Jun 2016 8:44 am
View user's profile Send private message View poster's gallery Reply with quote
Saulius Ruzgys
 


Member Since: 02 May 2016
Location: Wisbech
Posts: 15

United Kingdom 2007 Discovery 3 TDV6 SE Auto Unknown ColourDiscovery 3

It's disco 3, 2007
Display says normal height
  
Post #166929718th Jun 2016 10:16 am
View user's profile Send private message View poster's gallery Reply with quote
tayaste
 


Member Since: 15 May 2013
Location: Chester
Posts: 7633

United Kingdom 2008 Discovery 3 TDV6 HSE Auto Stornoway GreyDiscovery 3

Have you measured it?
   
Post #166938818th Jun 2016 2:49 pm
View user's profile Send private message View poster's gallery Reply with quote
Saulius Ruzgys
 


Member Since: 02 May 2016
Location: Wisbech
Posts: 15

United Kingdom 2007 Discovery 3 TDV6 SE Auto Unknown ColourDiscovery 3

No I didn't
But I own car for a year and I see that this is no normal height, Monday I taking it to Land Rover
  
Post #166939118th Jun 2016 2:53 pm
View user's profile Send private message View poster's gallery Reply with quote
DSL
Keeper of the wheelie bin 


Member Since: 11 May 2006
Location: Off again! :-)
Posts: 73078

Ukraine 

Pic would be good to see what it's like. Thumbs Up
   
Post #166939218th Jun 2016 2:55 pm
View user's profile Send private message View poster's gallery Reply with quote
Saulius Ruzgys
 


Member Since: 02 May 2016
Location: Wisbech
Posts: 15

United Kingdom 2007 Discovery 3 TDV6 SE Auto Unknown ColourDiscovery 3

Click image to enlarge


Click image to enlarge

This is the most it going up

Click image to enlarge


Click image to enlarge

This is normal height

And I just noticed that if I try lower it, it goes little bit down and then back up again and computer say clear obstacles
  
Post #166941218th Jun 2016 3:48 pm
View user's profile Send private message View poster's gallery Reply with quote
tayaste
 


Member Since: 15 May 2013
Location: Chester
Posts: 7633

United Kingdom 2008 Discovery 3 TDV6 HSE Auto Stornoway GreyDiscovery 3

Height looks OK to me. It sounds like youve got a different problem, the car thinks it's grounding when it isn't.
   
Post #166941618th Jun 2016 4:11 pm
View user's profile Send private message View poster's gallery Reply with quote
JMack
 


Member Since: 02 Aug 2014
Location: Edinburgh
Posts: 1517

Scotland 2006 Discovery 3 TDV6 Commercial Manual Java BlackDiscovery 3

Front looks lower than the rear.




Do you have a good jack to lift the car. Lift it as high as you can at one side/wheel and then if you start it it will think it is grounded and go to extended mode. Then take the jack down and away it should stay at extended mode. Then you can re-set it to normal and see what it does.

If it was me I'd do that just to see what happens. Also measure the distance from the centre of the wheel to the apex of the wheel arch.
  
Post #166942918th Jun 2016 4:29 pm
View user's profile Send private message View poster's gallery Reply with quote
Saulius Ruzgys
 


Member Since: 02 May 2016
Location: Wisbech
Posts: 15

United Kingdom 2007 Discovery 3 TDV6 SE Auto Unknown ColourDiscovery 3

Hello, do you mean lift one corner so wheel don't touch the ground and then start the engine?
  
Post #166943918th Jun 2016 4:42 pm
View user's profile Send private message View poster's gallery Reply with quote
JMack
 


Member Since: 02 Aug 2014
Location: Edinburgh
Posts: 1517

Scotland 2006 Discovery 3 TDV6 Commercial Manual Java BlackDiscovery 3

Yes, lift it as if you were taking a wheel off. And then start engine, in neutral! Wink A message should say something like, 'extended mode, clear obstruction and re-set suspension'. (I can't remember the exact message) and the suspension will rise another inch or so.
Lower the jack and move the vehicle forward or back a little.
Then see if any messages and look and see if it looks higher and is level.
Then select normal height and see what happens. Check levels etc.

Raise to off-road height first before jacking up.
  
Post #166944918th Jun 2016 5:05 pm
View user's profile Send private message View poster's gallery Reply with quote
Saulius Ruzgys
 


Member Since: 02 May 2016
Location: Wisbech
Posts: 15

United Kingdom 2007 Discovery 3 TDV6 SE Auto Unknown ColourDiscovery 3

Done it Still the same
When it says "suspension in extended mode" reset suspension if cleared obstacles " how can I reset it?
  
Post #166947118th Jun 2016 6:10 pm
View user's profile Send private message View poster's gallery Reply with quote
JMack
 


Member Since: 02 Aug 2014
Location: Edinburgh
Posts: 1517

Scotland 2006 Discovery 3 TDV6 Commercial Manual Java BlackDiscovery 3

Just move the suspension button to normal height.


Did it rise further than off-road height?

Did it look like all 4 struts were fully extended/higher than off-road?

When you select access mode does it drop right down?
  
Post #166948118th Jun 2016 6:21 pm
View user's profile Send private message View poster's gallery Reply with quote
Display posts from the last:  
Post Reply Back to top
Page 1 of 2 12>
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO3.CO.UK Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO3.CO.UK is independent and not affiliated to Land Rover.
Switch to Mobile Site