Member Since: 03 Jul 2014
Location: Malta
Posts: 23
Compressor pipe removal
Got this stuck. 10mm brass and pipe are out, but not the 8mm. No amount of persuasion worked. Is there any trick?
Tried to undo the nut holding the push-fit fitting but wouldn't turn much.
6th May 2016 8:40 am
il-bob
Member Since: 03 Jul 2014
Location: Malta
Posts: 23
Managed finally. Tapped in the brass pipe and screwed in a self tapping screw, which I've prised out. The brass pipe came out then using a flat screw driver I removed the rubber pipe.
Now dismantling again and cleaning..
Click image to enlarge
6th May 2016 4:04 pm
il-bob
Member Since: 03 Jul 2014
Location: Malta
Posts: 23
I bought the 8mm collet from rimmer bros and tried to put in today. I also replaced the o ring. But the collet wouldn't go in as far as it should. Any idea?
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
stuck. 10mm brass and pipe are out, but not the 8mm. No amount of persuasion worked. Is there any trick?
