JackoDisco07
Member Since: 18 Feb 2014
Location: Essex
Posts: 9
|
Unusual engine tone at 2000 revs in most gears |
|
Only had my disco 3 few months but have noticed that in most gears just above 2000 revs I get extra noise and a bit of vibration. It sounds like its coming from passenger side of the vehicle. I discovered the pollen filter cover is missing, so am replacing that as thought that might allow Has anyone come across this before or got any ideasto what it may be?
Cheers
Jack
|
21st Feb 2014 10:01 pm |
|
|
lunar
Member Since: 17 Jun 2012
Location: prestatyn
Posts: 93
|
I have the same thing and have had it for 10 months but I also get a power loss as well can't get to the bottom of it it happens at the point where the power comes in
|
21st Feb 2014 11:04 pm |
|
|
JackoDisco07
Member Since: 18 Feb 2014
Location: Essex
Posts: 9
|
I haven't noticed any power loss in mine as of yet. Replaced the pollen filter cover today and made no difference to mine either. Which gears do you notice this in on yours?
|
22nd Feb 2014 5:41 pm |
|
|
VMatas
Member Since: 26 Jan 2012
Location: Rybnik
Posts: 147
|
Check crossover pipe.
|
22nd Feb 2014 5:49 pm |
|
|
JackoDisco07
Member Since: 18 Feb 2014
Location: Essex
Posts: 9
|
Thanks. Will have a look over that tomorrow and then give it another run. It does sound like something isn't quite sealed. But must be at the 2000 rev mark causes something to reverberate.
|
22nd Feb 2014 5:55 pm |
|
|
VMatas
Member Since: 26 Jan 2012
Location: Rybnik
Posts: 147
|
Exactly same, strange engine sound (a bit with low tones) and vibrations, when my pipe was broken.
|
22nd Feb 2014 6:05 pm |
|
|
JackoDisco07
Member Since: 18 Feb 2014
Location: Essex
Posts: 9
|
How far down does the pipe run? There is no damage across the top of it that is visible. Is it best to take it off so you can look at it properly?
|
22nd Feb 2014 6:10 pm |
|
|
VMatas
Member Since: 26 Jan 2012
Location: Rybnik
Posts: 147
|
Take it down isn't easy task Try check with hand and visually for black soots.
|
22nd Feb 2014 6:18 pm |
|
|
JackoDisco07
Member Since: 18 Feb 2014
Location: Essex
Posts: 9
|
Thanks will give that a try.
|
22nd Feb 2014 6:27 pm |
|
|
JackoDisco07
Member Since: 18 Feb 2014
Location: Essex
Posts: 9
|
Haven't had a chance to check just yet, do I need to remove engine cover when I do? Also I have noticed sounds getting more obvious the more I drive it. Is there any danger of damaging any other parts in engine bay. I have quite a few miles to cover before I am going to be able to get it sorted.
Thanks
|
23rd Feb 2014 2:03 pm |
|
|
VMatas
Member Since: 26 Jan 2012
Location: Rybnik
Posts: 147
|
Serious damage can occur, if pipe is broken for example into fuel filter direction. Pipe can be accessed ONLY from under engine or body removal method. There you can find numerous themes about this problem:
http://www.disco3.co.uk/forum/search.php?s...rch_time=0
|
23rd Feb 2014 3:36 pm |
|
|
JackoDisco07
Member Since: 18 Feb 2014
Location: Essex
Posts: 9
|
Thank you. I think I will get it into a garage ASAP before doing too many more miles
|
23rd Feb 2014 4:32 pm |
|
|
lunar
Member Since: 17 Jun 2012
Location: prestatyn
Posts: 93
|
sorry jack, I havnt been on for a day or so, but mine does it in most of the lower gears as the power comes in but as I say mine has low power until it starts to make the noise a 2000 rpm then it takes off, where is the crossover pipe is it rubber or metal ?
|
23rd Feb 2014 9:18 pm |
|
|
JackoDisco07
Member Since: 18 Feb 2014
Location: Essex
Posts: 9
|
No worries. Oh right, I have no power loss and seems to be gears 3,4,5 mainly. I am taking it to be looked at today. I will let you know any findings
|
24th Feb 2014 10:09 am |
|
|
JackoDisco07
Member Since: 18 Feb 2014
Location: Essex
Posts: 9
|
Findings so far. Think we might have narrowed it down a bearing that has gone in the prop shaft. Have you had that checked on yours?
|
28th Feb 2014 6:33 pm |
|
|