rockcrawler
Member Since: 31 Oct 2012
Location: Ferring
Posts: 2884
  
|
Has anyone done this to rest their service message
Switch ignition OFF
Press and hold trip button
Turn ignition key to position ll
Note: If the service interval indicator function is not programmed the normal odometer and trip information will be displayed.
The message "SERVICE"will flash for 5 secs and then be permanently displayed.
Release trip button within 10 secs to display "DIST".
Within 10 secs press and hold trip button for at least 6 secs.
the message "RST" will be displayed for 5 secs followed by "END".
Release trip button.
Wait 10 secs
Switch ignition OFF
I thought you couldn't do it this way and it had to be plugged into diagnostic equipement  D3 Metropolis Bonatti Grey-Alpaca Leather-adaptive headlights-fridge-EGR blanking kit-Harmen Karden-Cruise-4x4 info enabled-Tinted Windows-Heated F&R Seats-Rosen rear Entertainment-LED'S everywhere -Smoked Side Repeaters-Rear Aircon-Vredestein Wintrac 4 Extreme-Puddle and Footwell Lamps-Stainless Steel Side Protection Tubes- NEW ASHTRAY ( thanks to dsd1036 )
Club BAS Remote FBH
Club MXS10 Ctek
Club Beanie Grill
Rear D4 Lamps
Geoff Gearbox Flush
BAS Remap
|
 16th Dec 2013 6:08 pm |
|
|
Chris1969
Member Since: 21 Jun 2011
Location: North Worcestershire (not far from Redditch)
Posts: 385
|
Hiya,
Depends on your year and if you have had any updates done.
I've got a 2005 so in theory, needs to be plugged in to reset it, but I had some software changes to get my clock on the dash and that software update has allowed for this functionality.
I think it's 2007 onwards you should be able to do it anyway, but as I say, if you have had a software update it may allow it to happen anyway 
Chris.
|
| 16th Dec 2013 7:13 pm |
|
|
|
|
Chris1969
Member Since: 21 Jun 2011
Location: North Worcestershire (not far from Redditch)
Posts: 385
|
Oooooo I was close with 07 haha
Yeah I didn't think mine would work, but it did. I found a thread saying something about if you have had a software update but don't know why it then works 
|
| 16th Dec 2013 8:08 pm |
|
|
