Member Since: 22 Feb 2013
Location: Northants
Posts: 888
ThanksYou remind me of a younger me, not much younger mind...perhaps even a little older!
15th Nov 2013 6:07 pm
sasdiscos
Member Since: 22 Feb 2013
Location: Northants
Posts: 888
Says they are for sport, hmmmm. Is it worth a try I wonder. What's the difference?You remind me of a younger me, not much younger mind...perhaps even a little older!
15th Nov 2013 6:13 pm
Disco_Mikey
Member Since: 29 May 2007
Location: Dundee, Scotland
Posts: 20784
Caliper mounting holes are in a different place between FFRR and RRS My D3 Build Thread
Member Since: 29 May 2007
Location: Dundee, Scotland
Posts: 20784
The harmonic damper on the caliper look like FFRR.
The RRS has big square blocks bolted on upright. The FFRR has blocks fitted lengthways, as seems to be in the picture.
Ask him to measure the centre of the mounting holes My D3 Build Thread
Member Since: 22 Feb 2013
Location: Northants
Posts: 888
Thanks guys. I have asked him for the measurements. What should they be? Many thanks. I would hate to waste my money.You remind me of a younger me, not much younger mind...perhaps even a little older!
16th Nov 2013 5:25 pm
John P
Member Since: 12 Aug 2011
Location: West Sussex
Posts: 1278
Centre to centre of the bolt holes is between 14.98 and 15.00 cm. My eye sight on my micrometer is not so good at this time of night.
Plus looking at the picture I cannot see the pins or the clips that hold the pads in. Remember to finish off the job properly you'll need the splash shields SEC000182 and SEC000192.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum