Member Since: 22 Nov 2019
Location: Turriff
Posts: 30
Suspension won’t rise after inner tie rod replacement
Hi this may be of my own doing but, I hope you guys can help out, cars been working well recently after changing the outer tie rod and wheel bearing and a new offside air spring, but the inner rod then needed changed so I removed the fuses to stop the car self leveling I jacked up the front to change the inner tie rods but as the rod that were delivered were wrong I left it jacked up until the new ones arrived (about 5days) fitted new inner tie rods put it back down on the ground, replaced the fuses and now the front end won’t rise, checked measurements on the diagnostic and the values seem well out. By looking at these numbers would they indicate the height sensors are the issue or do these just need reconfigured, I don’t think my diagnostic kit will allow me to change these settings it’s a Autel MaxiCOM MK808.
23rd Jul 2021 8:55 pm
eightfoot
Member Since: 12 Apr 2015
Location: sunny essex
Posts: 814
are the doors and bonnet shut then either switch to access or off road height then when it moved switch back to normal (obviously car should be running)please excuse any grammer/punctuation mistakes,i'm thick,thankyou
current vehicles 2005 d3 2013 d4
24th Jul 2021 9:13 am
Northerdiver1
Member Since: 22 Nov 2019
Location: Turriff
Posts: 30
All doors, boot and Bonnet are shut,when trying to move car to access height, car says it’s stuck on something and says moving to extended height but only the back raises, all fuses are good, and front valve block was changed just 4 weeks ago, it’s only stopped working after having the front end raised for a few days with the axels hanging at full extended length
24th Jul 2021 11:02 am
grzesiul
Member Since: 11 May 2008
Location: UK
Posts: 6415
try to do hard reset on it before anything else.
G
24th Jul 2021 12:31 pm
knwatkins
Member Since: 19 Sep 2018
Location: Poole, Dorset
Posts: 716
Check you haven't damaged the height sensors. The front right one looks out of whack compared to the rest.Kev
MY2014 L405 RR Vogue SE 4.4 SDV8 in Corris Grey
MY2010 L320 RRS HSE 3.0 TDV6 in Stornoway Grey
24th Jul 2021 12:46 pm
Northerdiver1
Member Since: 22 Nov 2019
Location: Turriff
Posts: 30
Hi all, car worked for all of 60 miles, and had to drive home on the bump stops at 30 miles per hour, so have checked all the wires and the height sensors and can’t see any physical damage, it went back to working correctly for say 30mins as I raised and lowered the suspension in one spot then started malfunctioning again, but I sat watching the live data and two things stood out the left height sensor now and again fluctuated to 140mm from 4mm but also the voltage for that sensor also fluctuated between 2.4volts and 4.6volt as the sizes fluctuated ,so is this more likely to be a faulty sensor or an issue with the wiring to the sensor?
Does anyone know which one drive which, does the voltage drive the change in height values or would the height change make the voltages fluctuate ?
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
