lukeob
Member Since: 02 Aug 2016
Location: Berkshire
Posts: 87
  
|
| Struggling to get spare wheel (with new tyre) wound up |
|
Have just had 2 new 20" front tyres fitted, one going on the spare. Has been sitting in the boot for a few weeks and just thought I'd put it bake properly.
After 40 mins of cursing and trying again and again, can't get the wheel wound up into correct position.
I have a TowTrust fixed bar fitted and haven't had any issues raising and lowering before.
Tried letting some air out, but don't want to let too much out in case my pump fails when needed.
Have managed to get the wheel up, rearmost end the highest, leaving the front end struggling to get up into the guide/shield behind the exhaust pipes. About 20 cm off the ground.
Previously had: Pirelli Scorpion Zero 255/50R20 109Y XL, which appear to have been superseded by: Pirelli Scorpion Zero Assimetrico 255/50R20 109W XL LR. Can't believe the tyre difference is so severe it would cause the issues? Luke
D4 MY13 HSE Lux
|
 25th Jul 2021 6:38 pm |
|
|
ronald.soak
Member Since: 29 Apr 2008
Location: London
Posts: 534
  
|
Any chance you wound the cable up without a spare wheel on it?.
Just wondering if the problem could be with the winch rather than the size of the tyre. Sorry if you are aware of this but without a load the cable can wind unevenly and jam up.
If you are going to test the winch best do it with a smaller wheel. Again apologies if you are aware of this issue.
John
|
| 25th Jul 2021 7:18 pm |
|
|
lukeob
Member Since: 02 Aug 2016
Location: Berkshire
Posts: 87
|
Hi John - Made that mistake before!  This time I left it down and cable tied it to the back of the tower for safe keeping. The winch work fine, it's just trying to get the wheel in at the right angle - it's pushing tightly at the front and the back Luke
D4 MY13 HSE Lux
|
| 25th Jul 2021 7:21 pm |
|
|
Oxford-boy
Member Since: 07 Sep 2015
Location: Oxford
Posts: 1113
|
Can be a complete b1tch imho, raising the spare again.
I hope it's not patronising to say try again and maybe use a piece of wood to pus the tyre towards the front as you wind the winch?
Has worked for me in the past...
 Jim
2014 Discovery 4 XXV SDV6 Causeway Grey
2016 Discovery 4 HSE Lux SDV6 Loire Blue - now gone
|
| 25th Jul 2021 8:13 pm |
|
|
nigethecat
Member Since: 11 Sep 2016
Location: Marnoch
Posts: 4244
 
|
The tow trust bar can get in the way (ask me how I know!  ) I found that undoing the winch all the way and then allowing the wheel to be pulled along the ground before it starts on it's journey up can help, also a bit of persuasion from a boot on the tyre helps as well. If you can swing the wheel so the end nearest the two bar goes in first that seems to help.
I managed to get GG AT3s running 275/45/20 in so you should be ok.
Also try giving the wheel well a quick brush out before you start as you'd be amazed how much "rubbish" ends up in there !
Good luck I want to see the sweets before I get into your windowless van... I'm not stupid!
Corris Grey D4 Commercial SE 2016
Zermatt Sliver 2007 D3 SE manual (gone)
Indus Silver D4 HSE 2015 (gone)
Bonatti Grey D3 HSE 2006 (gone)
White D3 S (LHD) 2007 (gone)
Firenze Red D4 HSE 2014 (gone)
Black RRS 3.6TDV8 2008 (gone)
Rusty Green Defender 110 1997 (gone)
Black FL2 HSE 2013 (gone)
|
| 25th Jul 2021 8:41 pm |
|
|
lukeob
Member Since: 02 Aug 2016
Location: Berkshire
Posts: 87
|
Thanks for the suggestions. I did have the help of my daughter winding up while I sat underneath kicking and pushing the far (front-facing) end up. It's a brand new tyre so there's no muck. Wonder if it's friction.
Wonders whether WD40 might be a good shout, it should hopefully be washed off by the time it's ever needed ! Luke
D4 MY13 HSE Lux
|
| 26th Jul 2021 7:45 am |
|
|
LT
Member Since: 31 Dec 2005
Location: South West
Posts: 23830
|
The WD40 silicone lubricant or similar might help. I’d be happier using that rather than the ordinary WD40. 2006 D3 HSE (Original & still the best)-GONE
2010 D4 HSE (A bit bling)-GONE
2014 D4 HSE (Almost too bling)-GONE
2015 D4 HSE (A heated what?)-GONE
2016 D4 Landmark (Written Off)-GONE
2016 D4 Landmark (Surely the last!) PD1881 rims-GONE
2017 FFRR SDV8 Autobiography (now semi-retired)
|
| 26th Jul 2021 8:48 am |
|
|
Sylvester19
Member Since: 17 Jul 2020
Location: Central Scotland
Posts: 128
|
I'd be a bit worried that you won't get the wheel back down when you need it most if its that tight!
|
| 28th Jul 2021 10:59 pm |
|
|
