WOODY179
Member Since: 01 Jun 2005
Location: Chesterfield
Posts: 3637
|
| Replacing door indicator housing |
|
When I collected my D4, unfortunately I did not notice until 4 months later that the passenger door indicator had a crack in it - obviously too late for it to be replaced by the dealer. Steve Smith kindly supplied me with a replacement set. Now the confusing part, the old and the new part look identical yet the new unit will not lock into the door properly - the slightest touch and it pops out again  I have tried the new units on the drivers door and they lock into the door perfectly.
|
 3rd Sep 2011 7:03 pm |
|
|
WOODY179
Member Since: 01 Jun 2005
Location: Chesterfield
Posts: 3637
|
Was down at the dealers yesterday and they couldn't fit the new unit either, there must be something slightly different on the passenger door as the new unit fits the drivers door fine and the original drivers door one will not fit the passenger door either.
The spring clip will not stay engaged when you push the unit home on the passenger door - will just have to keep altering the spring clip until it fits properly.
Last edited by WOODY179 on 6th Sep 2011 6:09 pm. Edited 1 time in total
|
| 6th Sep 2011 2:56 pm |
|
|
WOODY179
Member Since: 01 Jun 2005
Location: Chesterfield
Posts: 3637
|
success at last 
swapped the retaining clip from the old unit to the new one and it worked first time - clips looked identical but it must have been slightly altered by LR to fit properly.
|
| 6th Sep 2011 5:23 pm |
|
|
