Member Since: 28 Aug 2014
Location: Norfolk
Posts: 4469
Rear wheel bearing done
I spent Friday evening and Saturday morning doing a rear wheel bearing.
Click image to enlarge
The most trouble I had, was getting the EPB cable out of the back plate.
Re-assembly-
Bearing was dry. Looks like the grease had left via the inboard seal, on the CV side.
Cutting the inner race off the hub.
Richard
D3 SE 2007. Triumph 2.5Pi 1973. Ferguson TEA20 1948.
Discovery 2 4.0 ES 2001- Gone
Discovery 1 300Tdi ES '95 - Gone
Range Rover Classic '79 - Gone
9th Apr 2017 11:18 am
thommo1927
Member Since: 30 Sep 2016
Location: Cardiff South Wales
Posts: 416
Hi mate ,What were the symptoms of the bearing going ? On my disco 55 tdv6 now I've got a strange thumping noise coming from drivers side rear. When I'm turning left you can feel and hear a thumping just under the rear seat It goes quicker with speed Cheers
14th Apr 2017 8:54 pm
rrhool
Member Since: 28 Aug 2014
Location: Norfolk
Posts: 4469
I was aware that there was some movement in the hub for a while. My MOT man noticed it this MOT, and put an advise on.
I did begin to notice noises though. It sounded like a transmission whine, and sometimes a deep rumbling noise. Both speed related.
Since doing it, the car it transformed. No whining, no rumbling, and generally really quiet over bumps.
Yours sounds more like a CV, or differential issue?Richard
D3 SE 2007. Triumph 2.5Pi 1973. Ferguson TEA20 1948.
Discovery 2 4.0 ES 2001- Gone
Discovery 1 300Tdi ES '95 - Gone
Range Rover Classic '79 - Gone
15th Apr 2017 1:42 pm
thommo1927
Member Since: 30 Sep 2016
Location: Cardiff South Wales
Posts: 416
Thanks for the reply mate,It's strange cos it's sounds like the wheel is bouncing but only on left turn ?
15th Apr 2017 3:56 pm
cosmic329
Member Since: 17 Dec 2013
Location: Chichester
Posts: 177
thommo - did you find out what this was? I have a similar noise every now and again - like someone rapidly thumping their feet on the floor behind my driver's seat for a very short time and then goes as I accelerate. Sounded a bit like how you described yours...Discovery 4 SDV6 HSE '65 - Projects in planning phase!
Member Since: 30 Sep 2016
Location: Cardiff South Wales
Posts: 416
Hi Cosmic ,It was my rear drivers side tyre ,My front lower arms were shot and when I had them replaced I asked the garage to investigate the noise. The tyre was worn on the inside due to the arms ,I wasn’t convinced it was that simple. But it was.
Hope this helps mate
4th Dec 2017 6:24 pm
cosmic329
Member Since: 17 Dec 2013
Location: Chichester
Posts: 177
Thanks for the quick reply mate. I'll have to have a look over the obvious next weekend and then wait for it to get worse I think! Could be a number of things looking through the forum - just hoping something easy and not too expensive - yeah right! Discovery 4 SDV6 HSE '65 - Projects in planning phase!
@cosmic329 Yours sounds like the center bearing on the prop shaft has failed.
Flack
4th Dec 2017 6:50 pm
cosmic329
Member Since: 17 Dec 2013
Location: Chichester
Posts: 177
Thanks Flack - that's high up my suspect list too after reading the forum. Will have to look at the weekend.
I also have a wheel bearing on the way out as it is rumbling and whining at about 40 mph (had one done earlier this year and it sounds the same). Was hoping it was connected but think not. Going to put my warranty to the test again soon then!Discovery 4 SDV6 HSE '65 - Projects in planning phase!
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum