- You are currently viewing DISCO3.CO.UK as a guest - Register to take part or Log In
Discovery343
Member Since: 22 Jul 2005
Location: Hobart Tasmania Australia
Posts: 55
  
|
| Raised Air Intake & Cargo Barrier |
|
Can anyone recommend a true sealing air intake and cargo barrier for the Discovery 3 SE? 05 Discovery 3 SE TDV6 Chawton White with roof rails, driving lights, steel side protection rails. Rego: DISCO3
|
 31st May 2007 5:57 am |
|
|
PCH
Member Since: 12 Jan 2005
Location: Anywhere but work
Posts: 812
 
|
Safari 4x4 do a proper snorkel for the TDV6. A few of the forum members on here have them fitted.
http://www.safari4x4.com.au/docs/snorkel/land_rover.html
Milford do a cargo barrier. http://www.milfordind.com.au/shop/index.ph...ea92785d8d
Chris 2011 Discovery 4 (MY12) SDV6 HSE with General Grabber AT's, Traxide Aux Battery system, custom rear drawers and Autosafe half height cargo barrier
Gone - 2005 Discovery 3 TDV6 HSE
ARB Bull Bar, Warn 9.5XP Winch, IPF D/Lights, Cooper STT's, LR Raised Air Intake, Traxide aux battery system, custom drawers and half height Autosafe cargo barrier, Mitchell Bros 4x4 tow hitch
|
| 31st May 2007 7:18 am |
|
|
Take It Easy
Member Since: 05 May 2007
Location: Newcastle
Posts: 7
|
In terms of a cargo barriers, I had the Landrover supplied one installed around 6 weeks ago. It is made by Hayman Reece and has been available since about March apparently.
While I haven't seen alternatives in the flesh, it seems fine so far. Some points which may be of interest are:
1. It was installed by LR with the load space mat in place and still functioning, although this sort of defeats the purpose for mine in storing gear up high. I have since removed the loadspace mat.
2. It mounts to the floor to the 2 tiedown points closest to the back of the second row seats, in addition to 2 holes drilled up high above the inside of the tailgate, just under the roof, with basically flat bar running all the way forward to the top of the cargo barrier
3. With the second row seat headrests fully up, it is a good 100mm behind them, meaning that it probably eats into the cargo area a bit more than ideal.
Hope this helps
By the way, this is a great forum
|
| 31st May 2007 11:05 am |
|
|
simon_arch1
Member Since: 10 Apr 2006
Location: Melbourne Australia
Posts: 502
|
4x4intelligence.com.au can also supply a cargo barrier...
excuse the plug pls. - just letting people of alternatives 
cheers,
Simon D3 - Buckingham Blue, SE, TDV6, 06 model; chipped; underbody armour; Mickey Thompson ATZ 275/65-18 AND MAXXIS Bighorn muddies; rear wheel carrier from 4x4intelligence.com; iPOD aux connection! GME 3200 UHF - aerial mounted on wheel carrier  ; LR roof rails/cross bars; Autosafe cargo barrier, Safari Snorkel; Traxide - aux battery; ARB bull bar with Tigerz11 winch; Lightforce 240 XGT driving lights (mitchell bros tow hitch to come)
|
| 12th Jun 2007 12:33 am |
|
|
Rob Bruce
Member Since: 18 Jun 2006
Location: Canberra
Posts: 687
|
| Instalation of Safirey Snorkel |
|
Have had my snorkel in a box for some months now, due to no time to fit it 
Are there any tricks not in the instructions I should know 
I have some time to do my stuff as SWMBO is away  so will install it this weekend.
Wonder if she wil notice 
Rob
|
| 11th Jul 2007 10:38 am |
|
|
martin4x4
Member Since: 23 May 2005
Location: Norfolk, UK
Posts: 362
 
|
Takeiteasy,
Just as a matter of interest do you know the part number for the LR OZ cargo barrier, I wonder if it's the same as the ROW which is VUB501170. Discovery 3 XS Auto, Stornaway, Active rear diff.
|
| 11th Jul 2007 12:00 pm |
|
|
simon_arch1
Member Since: 10 Apr 2006
Location: Melbourne Australia
Posts: 502
|
I bought our safari snorkel last week too - looking forward to hearing how the install goes - contemplating paying someone else to fit it - but with the D3, am I right, you don't have to use a hole saw to drill big holes in the car? It just goes in place of the air inlet on the RHS??
cheers and good luck with fitment!
Simon D3 - Buckingham Blue, SE, TDV6, 06 model; chipped; underbody armour; Mickey Thompson ATZ 275/65-18 AND MAXXIS Bighorn muddies; rear wheel carrier from 4x4intelligence.com; iPOD aux connection! GME 3200 UHF - aerial mounted on wheel carrier ; LR roof rails/cross bars; Autosafe cargo barrier, Safari Snorkel; Traxide - aux battery; ARB bull bar with Tigerz11 winch; Lightforce 240 XGT driving lights (mitchell bros tow hitch to come)
|
| 11th Jul 2007 9:49 pm |
|
|
PCH
Member Since: 12 Jan 2005
Location: Anywhere but work
Posts: 812
|
Here are the instructions.
http://www.safari4x4.com.au/guides/ss385hf.htm
There is a lot more to installing one of thes than the LR raised air intake.
Chris 2011 Discovery 4 (MY12) SDV6 HSE with General Grabber AT's, Traxide Aux Battery system, custom rear drawers and Autosafe half height cargo barrier
Gone - 2005 Discovery 3 TDV6 HSE
ARB Bull Bar, Warn 9.5XP Winch, IPF D/Lights, Cooper STT's, LR Raised Air Intake, Traxide aux battery system, custom drawers and half height Autosafe cargo barrier, Mitchell Bros 4x4 tow hitch
|
| 11th Jul 2007 11:02 pm |
|
|
Rob Bruce
Member Since: 18 Jun 2006
Location: Canberra
Posts: 687
|
Simon,
Looks like some cutting and drilling, acording to instructions, let you know how I go.
Rob
|
| 12th Jul 2007 12:45 am |
|
|
LeighW
D3 Decade
Member Since: 31 Jan 2006
Location: Brisbane, AUS
Posts: 920
|
Discovery343 - Regarding the raised air intake, I opted for the LR OEM and fitted it without any great problems (however the LR supplied bolt for the top of the winsdcreen trim was way too short) and I also stuffed the original plastic air intake whilst removing it - the lugs on the bottom broke off and fell down in the lower mudguard area never to be seen again! I have just done around 3000 km from Brisbane to Darwin and then from Adelaide across to Canberra and the air cleaner is still pretty good. I was worried about loss of vision forward with a snorkel but the LR OEM is almost imperceptible. You do notice it when you get into and out of the the vehicle though. There is no great increase in air noise either, so that was a bonus.
Re the cargo barrier: simon_arch1 wrote:4x4intelligence.com.au ...just letting people of alternatives
Simon supplied one from 4x4intelligence and I fitted it the same afternoon. Little bit fiddly getting the upper rear bolts in though. I also painted the stays (to match my interior colour) that go from there back to the cargo barrier. One thing I did find is that even on the rearmost positioning of the adjustable stays the barrier is up against the rear headrests of the second row seats in my 5 seater. I might be tempted to adjust (read; drill some new holes) the stays so that there is a bitmore clearance as I can't raise the headrests unless I first release the seats from their upright position.
Other than the slight bit of fiddling for my 5 seater, I can recommend the price and speedy supply from 4x4intelligence. LeighW
The old girl is on her third engine...
* first ran a bearing (design failure in original engine)
* second had a failure of the water outlet on top of the engine (pls check yours)
|
| 12th Jul 2007 6:39 am |
|
|
Rob Bruce
Member Since: 18 Jun 2006
Location: Canberra
Posts: 687
|
| Safari Snorkel Instalation |
|
Just finished 
The instructions are quite folowable, but it says 180 minutes for the job 
I spent 1 hour last night takeing the trim etc off, then to install just over 4 hours OK I am not the fastest, the result was good
Some observations, the drilling of the A piller is the hardest , I tried to piolet hole it first to no avail  so resorted to useing some high speed drills, strange things these are, there German and need to run very fast, also run very hot, my Makita was not quite fast enough but it had to do , They however went straight through. There make is ARTU PROFI-LINE, I have used them quite a dit , they are for drilling very hard steel.
The bolts behind the snorkel are a  to do up , not much space to get your hand at them , some pacence is needed  .
The short of it is if you can spend the time at it go for it , if not let where you purchased it do it and let them try to do it in 180 minutes
Eneyway there was no bad language and a good result.
Rob
|
| 13th Jul 2007 4:12 am |
|
|
stevo68
Member Since: 23 Feb 2006
Location: Gold Coast
Posts: 49
|
Question on the cargo barrier not having had one before, once it is installed are you able to take it back out again? As mine is a 7 seater are you still able to use the 7 seats if the barrier is in there, thanks,
Regards
Stevo 2005 D3 HSE V8, General Tire AT2 255/55/R18, Kaymar Rear Bar and Wheel Carrier
Off Road: http://server1.pictiger.com/albums/563/ormeau-hills/
|
| 28th Jul 2007 7:37 am |
|
|
martin4x4
Member Since: 23 May 2005
Location: Norfolk, UK
Posts: 362
|
If you mean the Land Rover one, it is removable BUT you cannot use the last row of seats with it installed.
If you go to the Land Rover web site http://www.landrover.co.uk/gb/en/Owners/ab...erview.htm
and then select the Owner Information Web site you can download in pdf format the fitting and use instructions before you buy. Discovery 3 XS Auto, Stornaway, Active rear diff.
|
| 28th Jul 2007 7:57 am |
|
|
Take It Easy
Member Since: 05 May 2007
Location: Newcastle
Posts: 7
|
Hi martin4x4
In response to your question a couple of weeks back, the part number for the Aussie LR cargo barrier made by Hayman Reese is "RAA559". My apologies for the delayed reply but I've been away for a few weeks.
Cheers
|
| 29th Jul 2007 5:14 am |
|
|
simon_arch1
Member Since: 10 Apr 2006
Location: Melbourne Australia
Posts: 502
|
Stevo - the Autosafe cargo barrier supplied by 4x4intelligence.com.au is easily removed, once installed the first time - about 3-4 mins sees 4 screws undone and the barrier removed (or replcaed back in) - far simpler and easier I find even than the Milford barrier I had in my D2.
But - you do not use the 3rd row seats with the barrier in place. And note that this barrier can also be used behind the front seats of ever carrying a load and no passengers!
cheers,
Simon D3 - Buckingham Blue, SE, TDV6, 06 model; chipped; underbody armour; Mickey Thompson ATZ 275/65-18 AND MAXXIS Bighorn muddies; rear wheel carrier from 4x4intelligence.com; iPOD aux connection! GME 3200 UHF - aerial mounted on wheel carrier ; LR roof rails/cross bars; Autosafe cargo barrier, Safari Snorkel; Traxide - aux battery; ARB bull bar with Tigerz11 winch; Lightforce 240 XGT driving lights (mitchell bros tow hitch to come)
|
| 29th Jul 2007 12:20 pm |
|
|
|
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
DISCO3.CO.UK Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
|
|
