Advertise on DISCO3.CO.UK
Forum · Gallery · Wiki · Shop · Sponsors
DISCO3.CO.UK > Faults & Fixes (D4)

Park Distance Controls (PDC) fixed - with photo
Post Reply  Down to end
Page 1 of 1
JksD4
 


Member Since: 31 Mar 2015
Location: Highlands
Posts: 100

United Kingdom 2010 Discovery 4 3.0 TDV6 HSE Auto Stornoway GreyDiscovery 4
Park Distance Controls (PDC) fixed - with photo

Following failure of the front PDC earlier this year, (http://www.disco3.co.uk/forum/topic128990.html) recently the rear system starting behaving erratically.
IID revealed two sensor faults and two electrical faults with the rear system. I suspected the wiring as usual (have never had the sensors actually fail). Removed rear bumper (http://www.disco3.co.uk/forum/topic47084.html?highlight=remove+rear+bumper) and extracted the loom.
The main problem is Landrover's complete inability to properly protect vulnerable wiring!!
Continuity testing revealed three wire faults. These were cut and rejoined with crimps.
Photo 1 typical poor original wiring wrapping
Photo 2 corrosion damage to wire
Photo 3 crimped connections
Photo 4 connections sealed with self amalgamating rubber tape
Photo 5 fully wrapped wiring loom - same as repair done on fronts

Take care to maintain the wiring lengths for each sensor branch and the distances between them - the loom has to fit back into the polystyrene wiring trim before reassembly back into the bumper.

Whole job took about 3 hours, but a good hour wasted on rusted in screws on the rear mudflaps, so at least two hours needed.








 MY2010 D4 3.0 TDV6 HSE Stornaway grey 

Last edited by JksD4 on 20th Dec 2015 7:03 pm. Edited 2 times in total 
Post #158067520th Dec 2015 6:51 pm
View user's profile Send private message View poster's gallery Reply with quote
JksD4
 


Member Since: 31 Mar 2015
Location: Highlands
Posts: 100

United Kingdom 2010 Discovery 4 3.0 TDV6 HSE Auto Stornoway GreyDiscovery 4
Trim removal tools

These are available on eBay for £1.99
Absolutely invaluable, especially when removing the top 4 clips on the rear bumper - you need to hold the tailgate about 45 degrees open, lift the inner flap, and somehow get in the gap to pull the centre plastic pin out of the clip, before removing the remainder of the clip. These made the whole job much easier.
 MY2010 D4 3.0 TDV6 HSE Stornaway grey  
Post #158067820th Dec 2015 6:56 pm
View user's profile Send private message View poster's gallery Reply with quote
motolite
 


Member Since: 18 Mar 2013
Location: Sydney
Posts: 931

Australia 

Nice work John. Thumbs Up
  
Post #158073520th Dec 2015 9:37 pm
View user's profile Send private message View poster's gallery Reply with quote
Mogwyth
 


Member Since: 03 Oct 2014
Location: Pwllheli
Posts: 3976

Wales 2005 Discovery 3 4.4 V8 HSE Auto Zambezi SilverDiscovery 3

Thumbs Up

Will be doing the same job myself when I fit my rear wheel carrier.
 ==================================
05 D3 HSE V8 4.4
04 MG TF 135
03 MG TF 115 Cool Blue Edition
02 MG TF 160
00 Hymer B564 Lionheart
1971 Series III 109
 
 
Post #158076720th Dec 2015 10:38 pm
View user's profile Send private message View poster's gallery Post Reply
Display posts from the last:  
Post Reply Back to top
Page 1 of 1
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO3.CO.UK Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO3.CO.UK is independent and not affiliated to Land Rover.
Switch to Mobile Site