Hi All
I have a llD Tool being using now for a couple of years. I plugged it in today to check for any faults but it does not find any ( you might think this is good) but I know I have certain faults that never go away but are now not showing up?. There is an advanced tab that allows you too select what appears and I remember last time playing with these settings. Have I disabled anything from showing my faults? Any help would be gratefullD3 HSE
9th May 2019 3:10 pm
Dazz360
Member Since: 03 Sep 2016
Location: West Mids Walsall
Posts: 873
Has it got the latest softwareMetal auto sump & fluid change (3 hrs)
LR door puddle projectors (10 mins)
Tinted Bonnet wind deflector (10 mins)
All Intercooler pipes and Tbolts (2hrs)
3 injectors replaced so far (30mins)
Sunroof drain pipes both sides 2.5 hrs)
Rear discs, shoes,pads,callipers,flexi hoses, rigid brake line, n/s upper hub carrier bush and rear n/s upper arm (13hrs over 2 days)
9th May 2019 6:50 pm
IndusD4
Member Since: 01 Dec 2011
Location: Sydney, NSW
Posts: 308
There are settings to show unconfirmed faults. Maybe they were showing before and not now?
Ron2016 D4 TDV6 Corris Grey
IIDTool BT
9th May 2019 7:41 pm
Beno2
Member Since: 18 Apr 2009
Location: SE
Posts: 996
latest software undated and issue resolvedD3 HSE
9th May 2019 9:05 pm
Beno2
Member Since: 18 Apr 2009
Location: SE
Posts: 996
So I have fault
B1B78-84 (2F) System pressure - Bus signal/message failure - signal is below allowable range
( on 25-12-2018 20:14:02 at 136494 km
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
latest software undated and issue resolved
