Just ordered a BAS intercooler hose and despite a long search cant find any instructions on here about fitting it - preferably with some photos?
anyone know where they are or have advice on doing the change? Disco 3 2.7 TDV6 55 Buckingham Blue Base
15% tints / Group Buy Stainless Steel Sill Plates / Trillogy B144 tailpipes / Stupidly Large Steel Bull Bar 8)
EGR Blanking plates / Side Steps / Very Big LR roof Box / BAS remap
New AC condensor / New Clutch & DM Flywheel / New Air Compressor, pipe set & Relay/another new clutch plate thanks to SWMBO/ new cross over pipe (without the body coming off)
Suzuki GSX1400 - its all torque! 8)
Bayliner 175 Capri
Adria 660SP motorhome
5th Jan 2012 9:41 pm
bellautos
Member Since: 02 Feb 2006
Location: NorthYorkshire
Posts: 2532
Hi
Thank you for your order. The fitting is simple really.
Lift the bonnet and remove the plastic engine cover.
Undo the top hose clip with a screwdriver.
Remove 4 plastic grommet clips holding the lower plastic corner splash guard on. Drivers side front of wheel at the lowest point behind the bumper.
Undo the lower hose clip and pull hose off the intercooler.
Lift out the hose from the top.
Do all the same in reverse for refitting.
To reuse the hose clips you will need to remove then from the old hose with some pliers, they have a small retaining clip grabbing the hose to keep them still. I remove this part from the clip before reuse with the pliers.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum