Member Since: 18 Jan 2006
Location: Western Australia
Posts: 295
Independantley Powered Milemarker Hydraulic Winch
I've finally done it, after designing the power takeoff that went opposite to the way my pump went I have finally designed and installed the bracketry and power takeoff for an independent hydraulic pump which is powering my hydraulic winch.
Pics as below
Click image to enlarge
Click image to enlarge
Click image to enlarge
I'll be bush next weekend trying it out
16th Mar 2008 11:32 am
opodden
Member Since: 29 Jun 2006
Location: Elverum
Posts: 100
A bit off topic
Where did you get the bracket, belt etc to mount the pump?
The reason I'm asking is that I have a Premier Onboard welder in my old car, that I would like to move over to my Disco 3 TDV6. In this way I could establish an independent system, hopefully not upsetting the electronics too much.
Cheers,
OP
16th Mar 2008 4:29 pm
RichardK
Member Since: 18 Jan 2006
Location: Western Australia
Posts: 295
I have designed that myself, both clockwise and anticlockwise power takeoff, in this case clockwise.
For economy I had to make more than I needed so I have some left over, PM me if you want one.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum