Member Since: 24 Feb 2021
Location: Diamond Creek
Posts: 25
heater core replacement
I have recently finished replacing the heater core on my 05 D3 and I have a couple of observations. First up, the heater worked well on the driver side but not the passenger. When I removed the core water appeared to flow through it but a comparison of the new core weight to the original gave a good indication of blockage.
Having removed a lot of the centre console to get at the core, a look at the panels showed me that if I made a cutout of approximately 4"x 2" it would be possible to access and remove the heater without disturbing the centre console. There is enough room behind the trim panel to cut it in situ and refit the removed portion using anchor nuts.
This will save a lot of time for anyone contemplating a heater replacement and when the panel modification is painted it will be hardly visible.
1st Jan 2023 1:19 am
airmech953
Member Since: 24 Feb 2021
Location: Diamond Creek
Posts: 25
Hope this picture, that shows where I cut the panel, clears up any queries. once the panel is cut, a backer needs to be made. I use 1mm sheet steel, riveted to the cut portion and then secured to the larger panel with 10-32 csk screws which picked up anchor nuts on the backer plate
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum