Member Since: 17 Jan 2021
Location: Dundee
Posts: 4
FBH fault codes
He everyone, recently purchased my discovery 4 and found the FBH not to be working.
I have used this site for info to date and undertaken a few tests but I still can’t get it to go.
To date I have used the PC software to run the checks with the interface loom.
Initially I was getting a fuel pump code, pulled the pump off, blew lines through and checked component, it’s now working!
Everything appears to be working via the software v 2.16 but I can’t run it directly through the PC as it’s saying ‘NAK access denied’ and I don’t have the option of the ‘on’ control.
When I reset it and plug everything back in and run the engine as normal it starts up and runs but stops showing fault code 22h, resistance wrong. I believe this may well be the glow plug and it needs replaced?
Anyone any advice as I am now stumped and where can I get a new glow plug?
Thanks in advance
17th Jan 2021 6:38 pm
Delboy2972
Member Since: 17 Jan 2021
Location: Dundee
Posts: 4
I know there is a lot on here folks but I’m stumped!
Been at it again still coming up with the same code.
When I have the engine running I try running the component test on the fuel pump for 10secs when complete the green SHR light comes on and everything seems to start up on the unit, I get a bug puff of smoke and it locks out, the FD red light doesn’t come on at all.
Bumping for any help, please!
19th Jan 2021 3:33 pm
azurar01
Member Since: 24 Feb 2011
Location: Gloucestershire
Posts: 509
I found this document via another thread on the forum.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
