pelato
Member Since: 02 Feb 2010
Location: Devon
Posts: 5
|
EPB fault & seat belt warning |
|
Evening all.
Yesterday, my manual 07 SE is telling me that the EPB would no longer work on drive away, i had an amber warning light on the dash, no reversing lights and no gear number display on the dash. I ran through the procedure to reset the fault (low box, reverse, then through all the gears from 1-6, then switch off) and it cleared the fault. But hey presto, today the EPB fault is back already. Any Ideas??
Also, while i'm at it, can anyone tell me how i go about removing the very annoying seat belt warning chime, i'm a farmer and the car is mainly used across my land, thus, no need to wear a seatbelt. I asked the main dealer and they said they wouldnt do it.
Any help will be greatly appreciated.
|
13th Feb 2010 9:47 pm |
|
|
|
grzesiul
Member Since: 11 May 2008
Location: UK
Posts: 6266
|
with EPB my box also lost calibration another day showing brake light thing on the dash, scanned the ECU which had something around 10 other faults
took it in and it was sorted no time
|
13th Feb 2010 9:54 pm |
|
|
pelato
Member Since: 02 Feb 2010
Location: Devon
Posts: 5
|
thanks, the seat belt trick works a treat, a visit to the main dealer is in order then?
|
13th Feb 2010 10:19 pm |
|
|
grzesiul
Member Since: 11 May 2008
Location: UK
Posts: 6266
|
does that light go off when you switch the engine off for a minute or two??
|
13th Feb 2010 10:23 pm |
|
|
The Transformer
Member Since: 22 Jan 2010
Location: Leicestershire
Posts: 1791
|
Wasn't there something about this can be caused by poor connections to the brake light bulbs?
|
13th Feb 2010 10:26 pm |
|
|
|
10forcash
Member Since: 09 Jun 2005
Location: Ubique
Posts: 16534
|
you need to recalibrate the gearbox X-Y sensor, into low box, reverse with foot fully of the clutch until the 'R' shows on the IPK, then go through 1-6 waiting until each gear shows on the display, switch off, wait until the 'P' has extinguished on the IPK - sorted
|
13th Feb 2010 11:42 pm |
|
|
grzesiul
Member Since: 11 May 2008
Location: UK
Posts: 6266
|
it did not work on mine last time some other fault came up?!
|
14th Feb 2010 1:59 am |
|
|
pelato
Member Since: 02 Feb 2010
Location: Devon
Posts: 5
|
i have already re-calibrated the x-y sensor thing by putting the motor in low box then reverse and through all forward gears, this did clear the fault, but it re appeared again the next day.
|
14th Feb 2010 9:04 am |
|
|