Advertise on DISCO3.CO.UK
Forum · Gallery · Wiki · Shop · Sponsors
DISCO3.CO.UK > Technical (D3)

"E" in gear indicator..potential causes ?
Post Reply  Down to end
Page 1 of 1
euangibson
 


Member Since: 24 Dec 2010
Location: Borders
Posts: 11027

Scotland 2012 Discovery 4 3.0 SDV6 HSE Auto Firenze RedDiscovery 4
"E" in gear indicator..potential causes ?

Sorry if its been done to death,but did a search and couldn't find anything (and again,if its hidden in the handbook,apologies)
After start up,before selecting a gear (manual box) I get the aforementioned "E" on the lcd gear display.....I'm assuming,like everything electronic on this planet it stands for "error".....what are the potential causes ?
 "Better to remain silent and be thought a fool,than to speak out and remove all doubt" ?.....what rubbish...

Locking rear E-diff
RLD spare wheel protector & sump guard
Extended roof rails
Series 111 mudflaps
Black side tubes,grill and vents
Timed climate remote
Hids4u interior lights

D4 Firenze my2012 HSE
D3 Java 2005 SE manual (sold,sadly,thanks for the memories)
1966 '88 Series 2a....still starts in the morning better than I do... 
 
Post #82774822nd Aug 2011 8:13 am
View user's profile Send private message View poster's gallery Reply with quote
Bodsy
Site Sponsor 


Member Since: 06 Nov 2006
Location: In the Clubhouse
Posts: 21361

United Kingdom 2007 Discovery 3 TDV6 HSE Auto Java BlackDiscovery 3

Could try this...

Stevie B wrote:
Had this problem myself. Park Brake fault light! Loss of gear Indication Number on Dash. Loss of Reversing lights when in Reverse and no Reversing sensor. Otherwise car drove well Question

Went to an unnamed LR Dealer in Saltash, Cornwall. They quoted me almost a grand for a new clutch plus more if I had to replace the flywheel Exclamation Exclamation

I was a little strapped for cash and started asking round non LR dealers and one of them being a former LR Dealer mechanic told me it was the sensor (XY) that tells the Car what gear it is in and it needed resetting. Then he said it can easily be sorted and to do this before doing anything else...Idea

1) Find a long straight and quiet section of road.Neutral
2) Select LOW Ratio.Shocked
3) Reverse for about 200 yards or until you get the beep and the R on the dash gear number indicator. And then a tiny bit more for good luck. Stop, then...Neutral
4) Go forwards in 1st until number appears. Clutch pedal must be fully raised each time.Exclamation
5) Then up through the Gears waiting for each of the numbers to appear. Do not skip any gears!Mad
6) Stop at 6th, back into neutral, switch off engine.Confused
7) After a brief rest, I took a couple of minutes just to make sure all the bad ju ju was gone and to have a quick wee as it was just all too exciting.Whistle
8) Restart and select High Ratio and you're on your way..Laughing

I did this and problem fixed. This (wee optional) resets the XY sensor...Wink

However; if the light keeps coming back on check your revs when putting your foot down. If they slip up and slow down while the speed catches up then your clutch plates are on the way out. This eventually happened to me 40k miles after my first problem. As long as the clutch isn't juddering violently each gear change, then it should be a case of just new plates without a flywheel replacement...Confused

NB: In the case of having new plates the fault light will be lit upon receipt of your motor. Give it a few miles for the new plates to bed in then reset the XY sensor and the fault light will miraculously go out...8)

Hope this helps and saves someone forking unnecessarily when in a few minutes you can sort yourself out... Arrow

Good Luck...SB... Thumbs Up
 Bodsys Brake Bible

D4/D3 Remote FBH heat kits
BAS Remaps/ EGR Blank
Transmission Flush
Software updates/enabling


Clock/ SNOTM /3Flash / 4x4Info /BT Update /Service Reset/Error Codes / Gearbox Reset
See It Here 
 
Post #82777522nd Aug 2011 9:35 am
View user's profile Send private message View poster's gallery Send e-mail Reply with quote
euangibson
 


Member Since: 24 Dec 2010
Location: Borders
Posts: 11027

Scotland 2012 Discovery 4 3.0 SDV6 HSE Auto Firenze RedDiscovery 4

Cheers Bodsy......its still happily showing me which gear I am in,but the dealer replaced the clutch and flywheel just before I bought it so I'm now wondering if it is all related.
I will have a go at the above re-set and see what happens
Cheers Thumbs Up
 "Better to remain silent and be thought a fool,than to speak out and remove all doubt" ?.....what rubbish...

Locking rear E-diff
RLD spare wheel protector & sump guard
Extended roof rails
Series 111 mudflaps
Black side tubes,grill and vents
Timed climate remote
Hids4u interior lights

D4 Firenze my2012 HSE
D3 Java 2005 SE manual (sold,sadly,thanks for the memories)
1966 '88 Series 2a....still starts in the morning better than I do... 
 
Post #82778922nd Aug 2011 10:11 am
View user's profile Send private message View poster's gallery Reply with quote
bookert
 


Member Since: 21 Nov 2005
Location: North East Somerset
Posts: 29

United Kingdom 2006 Discovery 3 TDV6 S Manual Buckingham BlueDiscovery 3

Did going the the xy sensor calibration cure the E in the gear display? I have the same after the gearbox was removed/replaced to fit a new exhaust crossover pipe.
  
Post #8548533rd Nov 2011 9:34 pm
View user's profile Send private message View poster's gallery Reply with quote
euangibson
 


Member Since: 24 Dec 2010
Location: Borders
Posts: 11027

Scotland 2012 Discovery 4 3.0 SDV6 HSE Auto Firenze RedDiscovery 4

I actually tried to do it the other day.......but have now realised that I forgot to do the reversing bit first Embarassed ...now that you have rediscovered this thread,and shown me the error of my ways,I'm going to have a proper go at it tomorrow Thumbs Up
 "Better to remain silent and be thought a fool,than to speak out and remove all doubt" ?.....what rubbish...

Locking rear E-diff
RLD spare wheel protector & sump guard
Extended roof rails
Series 111 mudflaps
Black side tubes,grill and vents
Timed climate remote
Hids4u interior lights

D4 Firenze my2012 HSE
D3 Java 2005 SE manual (sold,sadly,thanks for the memories)
1966 '88 Series 2a....still starts in the morning better than I do... 
 
Post #8548703rd Nov 2011 10:08 pm
View user's profile Send private message View poster's gallery Reply with quote
hotrocks
 


Member Since: 05 Jan 2010
Location: England
Posts: 467

United Kingdom 2009 Discovery 4 3.0 TDV6 XS Auto Siberian SilverDiscovery 4

Mine did this last week.. its now having a new gear box, clutch, fly wheel, XYZ switch and a balancer pipe fitted at a cost of... oh... about 4 k by the time I am done

I had a new clutch 12 months ago as well so don't hold your breath, it could be that... but then again... its probably just the switch needed a reset Laughing
  
Post #8548883rd Nov 2011 10:37 pm
View user's profile Send private message View poster's gallery Reply with quote
Flack
 


Member Since: 06 Sep 2006
Location: Preston Lancashire
Posts: 6236

England 2007 Discovery 3 TDV6 XS Auto Stornoway GreyDiscovery 3

Euan

I would try the xyz meathod first fingers crossed..The old landys used to what we called wind up the box and a similar procedure was used to fix them but of course with out the electronics.

Flack Thumbs Up
  
Post #8549123rd Nov 2011 11:51 pm
View user's profile Send private message View poster's gallery Send e-mail Post Reply
Display posts from the last:  
Post Reply Back to top
Page 1 of 1
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO3.CO.UK Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO3.CO.UK is independent and not affiliated to Land Rover.
Switch to Mobile Site