nmwalsh
Member Since: 13 Aug 2015
Location: cape town
Posts: 2
|
| disco 4 2010 year (rhd )remote not unlocking vehicle |
|
l am working on a disco4 2010 3.0 l engine
the vehicle will not unlock with the remote but will start with the remote in the vehicle.
l have checked the fuses (fuse 1 pas,fuse 30 pas, fuse 32 pas,fuse 39 pas,fuse 44 passenger fuse box
the taildoor is also not opening .
i can see with autologic that the upper taildoor switch is not responding .
there are no faults showing in the keyless module or other modules on the vehicle .
the vehicle will lock and unlock with the drivers door switch ,except the tail door
i have removed the passenger front seat (front left side )and there is water in the channel where the loom runs.
i need to know where the radio receiver for the remote is located (high frequency) (433mhz)?
the workshop manual shows it is next to the keyless module .
i have moved the drivers side rear trim away a bit to unplug and replug the keyless module .
i do not see the receiver there.
is it in the upper tail door?or in the roof?
the diagram shows there is a join (SJ206) in the loom from (fuse 1 passenger) to the radio receiver.
where is this join ?its a RED/BLUE 0.5MM WIRE .
i have tested the remote with a transmitter/receiver kit that i bought .the leds light up when i press each button on the remote .
i
|
 2nd Sep 2020 4:31 pm |
|
|
Flack
Member Since: 06 Sep 2006
Location: Preston Lancashire
Posts: 6234
  
|
It will be the green wire splice thats corroded, search on here for green splice wire.
Flack 
|
| 2nd Sep 2020 6:50 pm |
|
|
