Member Since: 02 Apr 2025
Location: West Midlands, Tamworth
Posts: 173
The bolt idea pictured above is a stroke of genius (thankyou for sharing)
I did make a small improvement - which was to fit 2 nuts to the bolt - loosely together & put 3 blobs of mig weld to the nuts....
This gave me a much longer Nut to wind off, & push the hub off even easier.
I just dun the 2nd hub bearing - sooooo much easier I only a few wallops with the hammer to crack the two parts enough to squirt some WD40...
The wind the nuts & bolt... & the hug drops off
Last edited by Grant-B on 22nd May 2025 4:06 pm. Edited 1 time in total
Good idea that about adding more nuts. I don’t have a welder but was lucky enough that once I got the hub out so far it came out easily. I have reassembly to do today so hope it goes smooth
17th May 2025 8:45 am
Grant-B
Member Since: 02 Apr 2025
Location: West Midlands, Tamworth
Posts: 173
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
