Member Since: 23 Nov 2008
Location: Cheshire
Posts: 3646
That screw could cause endless damage chaffing on cables, rubbing a hole in the chassis or body - may be best to take the fridge out again to retrieve it
It will always be in the back of you'd mind ........
23rd Oct 2016 10:11 am
DSL Keeper of the wheelie bin
Member Since: 11 May 2006
Location: Off again! :-)
Posts: 73120
I can live with it, if my OCD allows me.
23rd Oct 2016 10:28 am
BBDisco3
Member Since: 23 Nov 2008
Location: Cheshire
Posts: 3646
Have you removed it again yet
23rd Oct 2016 1:22 pm
DSL Keeper of the wheelie bin
Member Since: 11 May 2006
Location: Off again! :-)
Posts: 73120
Absolutely not, it's staying!!! Just changed the battery, reset the BMS, fiddled with a few CCF settings, had a mooch at some live values, replaced all the locking nuts, checked the torque on all of the nuts, washed the Pyrenean mud off Old-D and had a bit of a tidy up in both cars. That's enough strenuous exercise for me today.
23rd Oct 2016 2:20 pm
BBDisco3
Member Since: 23 Nov 2008
Location: Cheshire
Posts: 3646
Yes time to rest........... and ponder ............ now where is that screw
23rd Oct 2016 4:56 pm
DSL Keeper of the wheelie bin
Member Since: 11 May 2006
Location: Off again! :-)
Posts: 73120
Leaving it there. Means if I need one I know where one is. Vaguely.
23rd Oct 2016 5:02 pm
BBDisco3
Member Since: 23 Nov 2008
Location: Cheshire
Posts: 3646
Will only take 20 minutes second time around.
Just time to complete before it's dark
23rd Oct 2016 5:08 pm
DSL Keeper of the wheelie bin
Member Since: 11 May 2006
Location: Off again! :-)
Posts: 73120
Shame it's already dark. Plus exceeded my allowed tinkering time so SWMBO would put the kibosh on that.
23rd Oct 2016 5:12 pm
BBDisco3
Member Since: 23 Nov 2008
Location: Cheshire
Posts: 3646
Well you have all evening and night to give thought to it
23rd Oct 2016 5:15 pm
michael calvert
Member Since: 03 Dec 2011
Location: West Yorkshire
Posts: 519
Fit mine last night thanks to Dan at duckworth.
Few very brave pulls and then one that went "either come off or I'll be replacing it!" Ah then to get it in ....the feed wire already there is very short and what a squeeze hut it's in and the trim seems to be clipped back ok....for now at leastD3 gone
Rrs 3.0 tdv6 hse nara bronze - going
D4 landmark waitimo grey
4th Nov 2016 7:59 pm
DSL Keeper of the wheelie bin
Member Since: 11 May 2006
Location: Off again! :-)
Posts: 73120
BBDisco3 wrote:
Well you have all evening and night to give thought to it
Been almost a couple of weeks and the lost screw is stil in there.
However dropped a car key down the gap between the centre console and the seat and every time I touched it I knocked it back under the seat support. One torx thingie found, rear seat bolts removed, seat back lifted and key retrieved, that's enough disassembly for one month.
4th Nov 2016 8:51 pm
DSL Keeper of the wheelie bin
Member Since: 11 May 2006
Location: Off again! :-)
Posts: 73120
michael calvert wrote:
...the feed wire already there is very short
Has same issue until I realised it needed routed round the side to meet the socket where it was before I cut the fridge-end socket free.
4th Nov 2016 8:54 pm
BBDisco3
Member Since: 23 Nov 2008
Location: Cheshire
Posts: 3646
DSL wrote:
BBDisco3 wrote:
Well you have all evening and night to give thought to it
Been almost a couple of weeks and the lost screw is stil in there.
However dropped a car key down the gap between the centre console and the seat and every time I touched it I knocked it back under the seat support. One torx thingie found, rear seat bolts removed, seat back lifted and key retrieved, that's enough disassembly for one month.
Yes but............ that screw will by now be chaffing the cables
It must be so close to piercing the insulation, then a little bit of moisture and then, before long .....
4th Nov 2016 9:18 pm
COMMANDERBOSTON
Member Since: 05 Jan 2017
Location: HAMPSHIRE
Posts: 77
Hi guys are there any cubby cool boxes left for purchase, regards Phil.
15th Jan 2017 4:16 pm
dgardel
Member Since: 03 Nov 2009
Location: Greater Venice
Posts: 2025
Bigcol66 wrote:
Are these still available? I am changing my D4 and the new one doesn't have one.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
