Baloo
Member Since: 26 Apr 2008
Location: Wiltshire
Posts: 39
|
I have just bought a new bumper with all the Gizmos as mine had nothing on it, has any body got instructions or better still, some pictures on the sequence of events leading to non broken brackets and complete fingers.
Thanks in anticipation.
|
27th Sep 2008 7:59 am |
|
|
|
Jimbob Squarepants
Member Since: 27 Oct 2007
Location: Miles Away from Home
Posts: 1063
|
Remember that if you are fitting front PDC it needs to be activated in the ECU - it's not just plug-and-play. I believe you need to take it to a dealer or someone with the right software (such as our very own Tenforcash).
Do you already have rear PDC?
Not sure about the fog lamps - these may need activating too. Too much intellectual firepower can damage your common sense.
|
27th Sep 2008 9:53 am |
|
|
Baloo
Member Since: 26 Apr 2008
Location: Wiltshire
Posts: 39
|
Thanks for the replies, it looks simple enough but fraught with possibilities to break clips etc. But £300 labour charge buys a lot of clips, so here goes.
Yes I do have rear PDC.
|
29th Sep 2008 8:06 am |
|
|
MacLeod 313
Member Since: 18 Apr 2008
Location: away
Posts: 10723
|
it is'nt a major issue changing the bumper, I did it when I put on the A Bar, I removed the items in this order
1. Grill, clips at top and 3/4 way down
2. Headlights, lift u tabs so that hole is level with locking tab on light, unplug wiring
3. Bumper, Screws in frount of Rad, screw inner wing where headlights are, in wheelarch and below bumper
4. Unclip front half of wheel arch trims, no need to remove.
On the O/S where the headlight was the wiring should be there to plug in the PDC as well as the light. Just plug in and the contact TFC to enable them.
I may have missed something or screws, but if you get resisance then there is a screw miss, dont worry though its an easy job.
|
29th Sep 2008 9:43 am |
|
|