Member Since: 01 Jan 2008
Location: wiltshire
Posts: 5779
BLANK FACIA DISPLAY ON TDV6 S
Can anyone help?
On the left hand side of the facia panel you have the little red alarm lights x 2, above that we have a screen that doesnt seem to display anything!
Raise the suspension, light comes up and the led reading in the middle of the panel says "rising to off road whatever" and the symbol displays on the right hand side of the dash, but nothing on the left, any reason, is it coz mines a "S" or what?
What light comes on when you raise the suspension (a photo would help here)?
The only thing you should get is the message and symbol in the message centre (that's the LCD screen in the middle) The End
15th Jan 2008 11:28 pm
character
Member Since: 01 Jan 2008
Location: wiltshire
Posts: 5779
I thought you were going to say that re a photo, bloddy car at the stealers (2nd time this week)
Anyone else got one they can post, pretty please!!!
15th Jan 2008 11:32 pm
wiggs
Member Since: 03 Sep 2006
Location: Manchester
Posts: 14368
Is this what your after
G4 Gone ...but not forgotten
16th Jan 2008 1:39 am
character
Member Since: 01 Jan 2008
Location: wiltshire
Posts: 5779
thats the kiddie!!!
On the left hand side below the rev counter and the two alarm warninglight, there are the symbols illuminated (in your picture) in their own enviroment (not to be confused with the main one centre). Anyhow when you change say for example to snow/ice setting on all terrain, the symbol illuminates in the centre, but should the light go on in the left hand side box as well or does that happen only when the setting fails?
16th Jan 2008 11:52 pm
simon
Member Since: 11 Jan 2005
Location: Shropshire
Posts: 18296
There are no lights for Terrain Response. Only a message to say that a TR mode has been selected. You will also see an icon for raised or lowered ride height (not for normal ride height once changed). This then goes away and will show the steering wheel angle if it veers off centre too far. This will also go once straight ahead is achieved.
The manual will show you all the possible messages and what appears when.
The symbols on the left side are lit when Hill Decent is selected manually or by the TR program, also for when low range is selected.
Again the manual tells you which are for what function, warning. Green is good, Red is bad, Orange is a warning.
17th Jan 2008 12:00 am
character
Member Since: 01 Jan 2008
Location: wiltshire
Posts: 5779
The thing is, I'm not getting anything show up in that left hand side led enviroment... hence this posting?
I though it was down to the model being the basic S, but from what you are saying, its not the case!
17th Jan 2008 1:36 am
wiggs
Member Since: 03 Sep 2006
Location: Manchester
Posts: 14368
Try selecting hill decent or low ratio ...see if any thing lights up then !!G4 Gone ...but not forgotten
17th Jan 2008 1:42 am
character
Member Since: 01 Jan 2008
Location: wiltshire
Posts: 5779
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
