Member Since: 26 Apr 2014
Location: Leamington Spa
Posts: 434
Altox app
Hi,
Looking for some help with the Altox app.
My heater only stops alight (smoke seen)for approx 3 minutes before I get error 5 .
Looked at the diagnosis on the app and I can see the heater temp rise then after about 2 mins the flame sensor changes from no to yes then after about 3 mins flame sensor changes back to no.
So questions are-
1) when lit and working ok should the flame sensor say yes or no
2) Do you think a strip down an clean would cure the error 5.
Error 5 description-
Flame was detected prior to combustion1) The reason for the air intake pipe or exhaust gases. 2) The reason for the fuel system. 3) Check the pump dispenser. 4) Check the electrical system pin filament.
Many thanks
12th Nov 2017 5:52 pm
F355GTS
Member Since: 10 Nov 2008
Location: North Hampshire
Posts: 849
My flame sensor says yes while the heater is litMark
12th Nov 2017 6:13 pm
Bodsy Site Sponsor
Member Since: 06 Nov 2006
Location: In the Clubhouse
Posts: 21361
The flame sensor will only say YES when the FBH is running at proper speed/burn.
Three minutes sounds like it’s started running up and then goes to cool down mode.Bodsys Brake Bible
Clock/ SNOTM /3Flash / 4x4Info /BT Update /Service Reset/Error Codes / Gearbox Reset See It Here
11th Dec 2017 10:43 pm
Leon
Member Since: 26 Apr 2014
Location: Leamington Spa
Posts: 434
Both messages I got mentioned altox.ru and altox .run. and about a update.
11th Dec 2017 10:49 pm
dgardel
Member Since: 03 Nov 2009
Location: Greater Venice
Posts: 2025
Bodsy wrote:
Notification of the update to the app?
Sounds like a typo. I couldn’t see the same typo on the emails I got from them.
I received the app update notification from Altox (finally it's possible to manage more cars) and the mail is "correct": info@altox.ruDiscovery 5 tdv6 HSE Corris Gray Outback Engineering Limited Edition
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum