I have a 2011 D4. 3.0 l diesel and have the Normal height only issue.
Initially it could be cleared by switching everything off and it would go away.
After about a fortnight fault would come on about 30 seconds after engine start and not clear.
The next morning it was found sitting low on the bump stops.
At this point the compressor was timed and ran for about 9 seconds and then cut out at the same time as the normal height only message popped up. The toggle for access or off road height button dosent do anything
Checked all fuses and changed the relay but no change
After looking through the forum convinced myself it was the air drier issues but went mad and
bought a complete AMK compressor thinking this would cure all ills.
Eldest offspring kindly fitted new compressor unit yesterday but sadly no change apart from now if you press the toggle switch for off road height the compressor just runs and runs
Now at wits end as what to try next.
27th May 2018 11:08 am
Narpy
Member Since: 18 Jul 2011
Location: Stockport
Posts: 7830
Get the codes read and report back. Mods:
Front Fogs + Halos
FBH Remote Control
The 1st Ever RRS Modded Grill
Garmin Nuvi + D4 Surround + Reversing Camera.
D4 Steering Wheel.
Rear Boot Spoiler.
Twin Brake Lights.
Wing Mirror Indicator Repeaters.
Long Roof Rails
Make your own Narpy grill thread
I'm not scared, I'm outta here.
27th May 2018 11:38 am
MikeBob
Member Since: 19 Sep 2016
Location: Pretoria
Posts: 105
Sounds like you have a leak somewhere
27th May 2018 1:28 pm
Heidi Vodka
Member Since: 28 Mar 2018
Location: UK
Posts: 5
Suspension Fault C1A13 Pressure does not increase when venti
I had the normal ride height only problem. Replaced the AMK compressor with a new one and now getting 'Suspension Fault.. Managed to borrow a code reader and get the fault C1A13 pressure does not increase when venting gallery.
Any ideas folks
Regards
28th Jun 2018 12:10 pm
djcleckie
Member Since: 08 Feb 2010
Location: Highlands
Posts: 189
Have a look at the links below there is a lot of discussion/advice to be found.
Dave2005 SE Manual Cairns Blue
Faultmate MSV2
Series 2 - long gone
RR Classic long gone.
Disco1 believe its still going as a farm vehicle in France.
28th Jun 2018 2:19 pm
Heidi Vodka
Member Since: 28 Mar 2018
Location: UK
Posts: 5
C1A13 Pressure does not decrease when venting gallery
Hi Folks,
I've made some progress but not even more confused.
New AMK compressor fitted and now back to normal height with no faults showing and the up/down switch illiuminated. All is well and good until you try and go to 'access' or 'off road height' and you get the 'bong of doom' and the yellow warning triangle on the dash. The code reader then comes up with the C1A13 Pressure does not decrease when venting gallery. Fault then clears if you switch off the ignition and restart. Ive blown through exhaust line through and tht is clear. I ran a temp supply to the Pilot exhaust valve on the compressor and this sound to be operting ( clicking)
Any idea what to try next.
Also I'm confused why the galley venting issue comes up if you are trying to raise the vehicle. Why does it want to vent galley you need more air to raise the bags????
Thanks
20th Jul 2018 5:47 am
Narpy
Member Since: 18 Jul 2011
Location: Stockport
Posts: 7830
Thanks for this. As the exhaust valve is within the compressor which is brand new should I be sending it back ??
Secondly any info on how check if the exhaust solenoid is receiving a signal.
Regards
Neil
20th Jul 2018 9:41 am
Narpy
Member Since: 18 Jul 2011
Location: Stockport
Posts: 7830
I think I'd start checking for a possible wiring issue within the looms locally to the compressor.
Your AMK might be ok but not receiving a signal due to faulty wiring. You're going to, at least, need to eliminate that possibility before removing parts and sending them back.Mods:
Front Fogs + Halos
FBH Remote Control
The 1st Ever RRS Modded Grill
Garmin Nuvi + D4 Surround + Reversing Camera.
D4 Steering Wheel.
Rear Boot Spoiler.
Twin Brake Lights.
Wing Mirror Indicator Repeaters.
Long Roof Rails
Make your own Narpy grill thread
I'm not scared, I'm outta here.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum