Evenin all,
just fitted some sidesteps and front and rear mudflaps. All went well and the car looks great.
My question is about the fitting of a bright finish air intake grille. How do I gain access to remove and refit the grille?
I have also bought bright finish door waist trims. The instructions are quite specific about not fitting them unless the temp. is a minimum 20 deg C. for 24 hours to allow the bond to complete. So that will be August then!
AlanTDV6 SE auto, Java / Alpacca
2010 Mini Cooper S Conv. Pepper White, Blue roof
2010 Jaguar XJ, Caviar with Cashew seats, B&W 1200W Hifi
27th Apr 2006 8:04 pm
Pelyma
Member Since: 06 Jan 2005
Location: Patching, Sussex
Posts: 15496
I used a hair dryer to warm them (the rubbing strips) up.DS3 TDV6 HSE - Silver with Alpaca (old one) Gone
DS3 TDV6 HSE- Silver with Alpaca (new one) Gone
D4 HSE Lux - Montalcino Red Gone
Porsche Cayenne V8 Diesel S
Hi just on the bottom edge there are two little caches on the inside you need something thin to push up to releec them and it will pull out OKHome of RLD Hidden winch mounts Spare wheel Locks Trailer Body Fabrication ray@rld-tech.co.uk D3/4 sump plates MY 14 sump plates and the Discovery Sport wheel protectors Discovery 5 wheel locks
more Helsport tents and other things for camping Law of Mechanical Repair:
"After your hands are coated with grease, your nose will begin to itch and you'll have to pee!"
That's great,
thanks for all the advice.TDV6 SE auto, Java / Alpacca
2010 Mini Cooper S Conv. Pepper White, Blue roof
2010 Jaguar XJ, Caviar with Cashew seats, B&W 1200W Hifi
27th Apr 2006 10:33 pm
DG Site Moderator
Member Since: 12 Dec 2005
Location: The Gaff
Posts: 50981
Re: air intake grille
afp001 wrote:
I have also bought bright finish door waist trims. The instructions are quite specific about not fitting them unless the temp. is a minimum 20 deg C. for 24 hours to allow the bond to complete. So that will be August then!
Alan
Alan, If you have double radiators - put your heating on about 21oC - lay the strips across the top for a few hours - after doing your measurements, whip them straight out to the motor and stick them on - works a treat - as long as it's mild then don't worry too much about the outside temp thereafter, its the fitting temp thats critical 21 year LR veteran > D2 GS 2003 > D3 S 2006 > D3 HSE 2009 > D4 HSE 2013 > D4 HSE 2015 > D5 HSE 2018 > DS HSE R-Dynamic P300e 2021
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
Law of Mechanical Repair:
